Results 211 to 220 of about 5,539,841 (381)

Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel

open access: yesAdvanced Engineering Materials, EarlyView.
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen   +4 more
wiley   +1 more source

Revised M06-L functional for improved accuracy on chemical reaction barrier heights, noncovalent interactions, and solid-state physics

open access: yesProceedings of the National Academy of Sciences of the United States of America, 2017
Ying Wang   +4 more
semanticscholar   +1 more source

Vacuum‐Formed Composites Based on a Polyolefin and a High Content of Biomass‐Waste Fillers

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown here that by the use of a very ductile polymer matrix, it is possible to vacuum‐form products that contain up to 25% of hard biofillers with still ductile properties. The results are promising and opens up for the use of engineered biocomposites derived from industrial side‐stream biofillers in vacuum‐formed products. A strategy to increase
Susanna K. Källbom   +6 more
wiley   +1 more source

W‐Based Thin Film Metallic Glasses Doped with Ni, Zr, and B for Industrial Applications

open access: yesAdvanced Engineering Materials, EarlyView.
This work is the first to deal with a comprehensive comparison of two metallic glass systems, W–Zr–B and W–Ni–B, in terms of their suitability for specific industrial applications. Their mechanical and tribological properties are compared and discussed in combination with structural homogeneity on different types of technically relevant substrates and ...
Zbynek Studeny   +5 more
wiley   +1 more source

CALPHAD‐Guided Prediction and Interpretation of Phase Formation in Ta–Mo–Cr–Ti–Al Refractory High‐Entropy Alloys

open access: yesAdvanced Engineering Materials, EarlyView.
This study designs Ta–Mo–Cr–Ti–Al refractory high‐entropy alloys with a disordered body‐centered‐cubic A2 crystal structure aiming for improved ductility, lower density, and oxidation resistance. Four alloy compositions are identified by thermodynamic calculations.
Kateryna Khanchych   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy