Low-cost technology for the integration of micro- and nanochips into fluidic systems on printed circuit board: fabrication challenges [PDF]
, 2012 Nowadays, micro- and nanochips are usually\ud fabricated with Silicon and/or glass. A simple, low-cost and\ud reliable integration packaging method that provides flexibility\ud to the incorporation of electronic and fluidic devices into a\ud system has ...
Akkerman, R. +6 more
core +9 more sources
Bose-Einstein Condensation on a Permanent-Magnet Atom Chip [PDF]
, 2005 We have produced a Bose-Einstein condensate on a permanent-magnet atom chip based on periodically magnetized videotape. We observe the expansion and dynamics of the condensate in one of the microscopic waveguides close to the surface.
B E Sauer +14 more
core +2 more sources
Investigation of Chip Deformation and Breaking with a Staggered Teeth BTA Tool in Deep Hole Drilling
Metals, 2019 The problem of chip breaking and evacuation is the key point of staggered teeth boring and trepanning association (BTA) drilling. The factors that influence chip breaking with staggered teeth BTA deep hole drilling are analyzed by using the chip bending ...
Xu-Bo Li +5 more
doaj +1 more source
The Influence of Point Angle and Fluctuation in Thrust Force On Chip Morphology
Hittite Journal of Science and Engineering, 2019 D rilling is a widely used machining method in engineering applications, playing a major part in machining operations. Chip morphology is an indicator, which shows the quality of machining. Especially, chip thickness ratio is a characteristic to show the
Zulkuf Demir
doaj +1 more source
Evanescent Waveguide Sensor for On-Chip Biomolecular Detection [PDF]
, 2017 This work presents analysis and development of an evanescent waveguide sensor system, which integrates an amorphous silicon photodiode and a glass-diffused waveguide.
Asquini, Rita +3 more
core +1 more source
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2020 Grinding chip thickness is an important parameter to reflect the grinding efficiency and investigate the grinding mechanism. Modeling of the chip thickness is generally based on a certain stochastic distribution model, like Uniform, Gaussian or Rayleigh ...
Chongjun WU +5 more
doaj +1 more source
Micromachines, 2023 This article presents the results of an experimental investigation into the effect of process parameters in the precision hard turning of Ti-6Al-4V on chip morphology at both macro and micro levels.
Elshaimaa Abdelnasser +4 more
doaj +1 more source
Integrating microfluidics and biosensing on a single flexible acoustic device using hybrid modes [PDF]
, 2020 Integration of microfluidics and biosensing functionalities on a single device holds promise in continuous health monitoring and disease diagnosis for point-of-care applications.
Dodd, Linzi +10 more
core +5 more sources
High yield fabrication process for 3D-stacked ultra-thin chip packages using photo-definable polyimide and symmetry in packages [PDF]
, 2014 Getting output of multiple chips within the volume of a single chip is the driving force behind development of this novel 3D integration technology, which has a broad range of industrial and medical electronic applications. This goal is achieved in a two-
Cauwe, Maarten +4 more
core +3 more sources
Aging in Primitive Societies: A Comparative Survey of Family Life and Relationships [PDF]
, 1962 This letter reports about unpatterned ferromagnetic NiFe/AlN multilayer composites used as advanced magnetic core materials for on-chip and interposer integrated inductances.
Ebefors, Thorbjörn +3 more
core +3 more sources