Results 11 to 20 of about 23,589 (286)
An 1 GHz class E LDMOS power amplifier [PDF]
33rd European Microwave Conference Proceedings (IEEE Cat. No.03EX723C), 2003 A class E power amplifier working at 1 GHz and with an LDMOS transistor as switching element has been developed.The circuit is implemented with lumped and distributed elements.An output power of 6.2 W at 69 %drain efficiency with a gain of 11 dB was obtained at 1 GHz.Both simulations and measurements of the amplifier are presented within this paper ...
Adahl, Andreas, Zirath, Herbert
openaire +4 more sources
An Off-Nominal Class E Amplifier—Design Oriented Analysis [PDF]
, 2023 This paper analyses an off-nominal Class E ZVS amplifier, with an R.F. supply choke and the switch on-duty ratio D = 0.5, to identify conditions for its high-frequency and high-efficiency operation.
Miroslaw Mikolajewski
core +1 more source
Design and Stability Analysis Techniques for Switching-Mode Nonlinear Circuits: Power Amplifiers and Oscillators [PDF]
, 2006 A design technique for kW level switching mode power amplifiers is presented. Several push pull pairs, independently tuned to Class E/Fodd, are combined by a distributed active transformer.
Jeon, Sanggeun
core +1 more source
IEEE Access, 2020 In this paper, a novel outphasing power amplifier (PA) based on class-E amplifiers with shunt capacitances and shunt filters is proposed. The new design provides high drain efficiency for both peak and back-off power levels.
Pavel Afanasyev +3 more
doaj +1 more source
Applied Sciences, 2021 This paper proposes an analytical expression set to determine the maximum values of currents and voltages in the Class-E Power Amplifier (PA) with Finite DC-Feed Inductance (FDI) under the following assumptions—ideal components (e.g., inductors and ...
Ingrid Casallas +4 more
doaj +1 more source
Comprehensive and Simplified Numerical Design Procedure for Class-E Switching Circuits
IEEE Access, 2021 This paper proposes comprehensive and simplified numerical design procedures for the class-E switching circuits with the Particle Swarm Optimization (PSO) algorithm.
Wenqi Zhu +3 more
doaj +1 more source
Analytical Design Equations for Class-E Power Amplifiers [PDF]
IEEE Transactions on Circuits and Systems I: Regular Papers, 2007 This paper presents the analytical solution in time domain for the ideal single-ended Class-E Power Amplifier (PA). Based on the analytical solution a coherent non-iterative procedure for choosing the circuit parameters is presented for Class- E PA’s with arbitrary duty-cycle and finite dc-feed inductance (e.g.
Mustafa Acar +2 more
openaire +1 more source
A Dual-Mode Highly Efficient Class-E Stimulator Controlled by a Low-Q Class-E Power Amplifier Through Duty Cycle [PDF]
, 2014 This paper presents the design flow of two high-efficiency class-E amplifiers for the implantable electrical stimulation system. The implantable stimulator is a high-Q class-E driver that delivers a sine-wave pulsed radiofrequency (PRF) stimulation ...
高明見 +1 more
core +1 more source
A novel inverse class E power amplifier topology
2013 21st Signal Processing and Communications Applications Conference (SIU), 2013 In this work, a 10 Watt inverse class-E power amplifier has been proposed, simulated, realized and measured for the 2.7-2.9 GHz wireless applications. In the proposed power amplifier topology distributed elements were used instead of lumped elements and their widths and lengths were optimized with AWR Microwave Office.
Kizilbey, Neslihan, Kizilbey, Oguzhan
openaire +2 more sources
A new series-L/parallel-tuned class DE-1 power amplifier
Dianzi Jishu Yingyong, 2018 This paper proposes a new series-L/parallel-tuned class DE-1 power amplifier. The theoretical analysis was conducted according to zero current switching(ZCS) and zero current slope switching(ZCSS) conditions.
Hua Zaijun +3 more
doaj +1 more source