Results 61 to 70 of about 9,586 (215)

A Modeling Perspective on the Lingering Glacial Sea Surface Temperature Conundrum

Geophysical Research Letters, 2022
The strong cooling during the Last Glacial Maximum (LGM, 21 ka BP) provides a rigorous test of climate models' ability to simulate past and future climate changes.
S. Krätschmer, A. Cauquoin, G. Lohmann, M. Werner   +3 more
doaj   +1 more source

Neighborhood Socioeconomic Status and Short‐Term Functional Outcomes in Systemic Lupus Erythematosus

Arthritis Care &Research, EarlyView.
Objective Individuals with systemic lupus erythematosus (SLE) can accumulate functional status (FS) impairment. We evaluated the association between neighborhood socioeconomic disadvantage, as measured by the Area Deprivation Index (ADI), and FS in a national SLE sample.
Baljeet Rai, Jessica Fitzpatrick, Jing Li, Eric Roberts, Patricia Katz, Laura Plantinga, Gabriela Schmajuk, Jinoos Yazdany   +7 more
wiley   +1 more source

A perspective on climate sensitivity

Solid Earth Sciences, 2020
The concept of climate sensitivity emerges for a quantitative measurement of the amount of warming in association with the increase of atmospheric CO2 concentration. Here we provide a perspective on the climate sensitivity and associated transient climate response using the latest literature, both of which have been highly concerned in recent decades.
Dabang Jiang, Na Wang
openaire   +2 more sources

Frailty Predicts Incident Osteoporotic Fractures in Veterans with Rheumatoid Arthritis

Arthritis Care &Research, Accepted Article.
Background/Objective Rheumatoid arthritis (RA) is associated with an increased risk of frailty and osteoporosis, but the relationship between frailty and incident osteoporotic fractures in RA is underexplored. Methods Data were from the Veterans Affairs Rheumatoid Arthritis (VARA) Registry.
Katherine D. Wysham, Hannah F. Brubeck, Aaron Baraff, Punyasha Roul, Namrata Singh, James S. Andrews, Grant W. Cannon, Gary A. Kunkel, Ted R. Mikuls, Bryant R. England, Dolores M. Shoback, Patricia P. Katz, Jose M. Garcia, Ariela R. Orkaby, Joshua F. Baker   +14 more
wiley   +1 more source

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

Advanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira, Marcella Gaute Cavalcante Xavier, Abdoul‐Aziz Bogno, Piter Gargarella, José Eduardo Spinelli   +4 more
wiley   +1 more source

Prediction of Surface Topography Parameters in Direct Laser Interference Patterning of Stainless Steel Using Infrared Monitoring and Convolutional Neural Networks

Advanced Engineering Materials, EarlyView.
This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky, Marcelo Sallese, Leander Kläber, Clemens Kuhn, Keming Du, Andrés Fabián Lasagni   +5 more
wiley   +1 more source

Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A

Advanced Engineering Materials, EarlyView.
The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han, Julian M. Rosalie, Jan Radners, Mauro Madia, Philipp von Hartrott, Birgit Skrotzki   +5 more
wiley   +1 more source

Current Status and Challenges in Data Collection for Aerospace Coatings Deposited by Plasma Spraying

Advanced Engineering Materials, EarlyView.
An innovative approach has been integrated into the GRENAT project to optimize plasma spraying and coating performance. Raw materials are accelerated and melted in the plasma generated by torches, creating coatings. Monitoring sensors collect process data which are combined with ex situ characterization data.
Lila Randriamananjara, Vincent Rat, Quentin Dubreuil, Patrice Valorge, Simon Goutier, Alain Denoirjean, Olivier Messe, Céline Ruelle, Jean‐Philippe Poli   +8 more
wiley   +1 more source

Experimental Characterization of Mycelium‐Based Composites Under Multiple Loading Conditions

Advanced Engineering Materials, EarlyView.
This study examines the mechanical response of mycelium‐based composites under compression, shear, and tension using mechanical testing and imaging methods. The comparison between unpressed and hot‐pressed specimens shows that hot pressing is associated with higher compression and shear stiffnesses.
Shaghayegh Elahi, Kimiya Tajik, Harvey Shaw, Matti Isakov, Sami Pajunen, Lauri Rautkari   +5 more
wiley   +1 more source

On the relationship between climate sensitivity and modelling uncertainty

Tellus: Series A, Dynamic Meteorology and Oceanography, 2017
Climate model projections are used to investigate the potential impacts of climate change on future weather, agriculture, water resources, human health, the global economy, etc. However, climate projections have a broad range of associated uncertainties,
Cecilie Mauritzen, Tatjana Zivkovic, Vidyunmala Veldore   +2 more
doaj   +1 more source