Results 11 to 20 of about 8,051,375 (277)
Numerical and experimental investigation of a confined plunging liquid jet system [PDF]
, 2012 In a confined plunging liquid jet (CPLJ) system, a liquid jet is allowed to fall in a partially submerged narrow downcomer tube. Liquid jet impingement at gas-liquid interface leads to entrainment of gas, which is dispersed down the downcomer tube in to ...
Mishra, A.
core +7 more sources
Jet mixing of water in crude oil pipelines [PDF]
, 1990 The jet mixing of water in crude oil pipelines by single nozzle and multi-nozzle mixers was studied by dividing the mixing domain into to three regions. the penetration. near field and farfield regions.
Fernando, L. M.
core +7 more sources
The effect of nozzle inclination on heat transfer in jet impingement systems [PDF]
, 1981 Jet impingement heating and cooling techniques are used extensively in industrial applications. in some of these installations, the axis of the jet can be inclined relative to the impingement surface.
Oladiran, M. T.
core +7 more sources
Experimental and computational studies of factors affecting impinging jet flowfields [PDF]
, 2009 An experimental and computational study was made of a single circular jet impinging onto a flat ground board. A 1/2" nozzle running at a fixed nozzle pressure ratio of 1.05 was used in the experimental phase (giving an nozzle exit Reynolds number of ...
Myszko, M
core +7 more sources
Energies, 2022 Thrust, propulsion, vector control of supersonic jets has been applied to jet and rocket engines, ejectors, and other many devices. In general, there are two approaches to this type of control, namely mechanical moving systems and fluidic thrust vector ...
Toshihiko Shakouchi, Shunsuke Fukushima
doaj +1 more source
Viscoelastic effects on the jetting–dripping transition in co-flowing capillary jets [PDF]
Journal of Fluid Mechanics, 2008 Linear hydrodynamics stability analysis is used to determine the influence of elasticity on the jetting–dripping transition and on the temporal stability of non-axisymmetric modes in co-flowing capillary jets. The critical Weber number for which axisymmetric perturbations undergo a transition from convective to absolute instability is calculated from ...
Montanero, J. M. +1 more
openaire +3 more sources
Energies, 2020 Supercritical carbon dioxide (SC-CO2) jet fracturing is a promising alternative for shale gas fracturing instead of water. However, most studies pay more attention to the fracture generation and ignore the flow characteristic of SC-CO2 jet fracturing in ...
Can Cai +5 more
doaj +1 more source
Engineering Proceedings, 2023 Fluidic thrust vectoring (FTV) control is a cutting-edge method used to manipulate the motion of an unmanned air vehicle when traditional control surfaces like elevators are not available. The primary purpose of employing FTV is to make the aircraft less
Ahsan Tanveer, Sarvat Mushtaq Ahmad
doaj +1 more source
Improvement of Laminar Lifted Flame Stability Excited by High-Frequency Acoustic Oscillation
Journal of Thermal Science and Technology, 2009 A high-frequency (20kHz) standing wave was applied to the unburned mixture upstream of a methane-air lifted jet flame using a bolt-clamped Langevin transducer (BLT) to improve stability.
Mitsutomo HIROTA +3 more
doaj +1 more source
Journal of Taibah University for Science, 2022 Combined turbulent wall and offset jets with and without the presence of a parallel co-flow stream are investigated using the k-ω turbulence model. We focus on the effects of co-flow velocity on the locations of various characteristic points formed owing
Nidhal Hnaien +5 more
doaj +1 more source