Results 291 to 300 of about 1,289,480 (334)

CO2 Corrosion in Wet Gas Systems

CORROSION 1996, 1996
Abstract The failure of a pipeline used to transport wet CO2 containing gas has highlighted the limitations that both intelligent surveys and ultrasonic testing (UT) inspection can have for the detection of internal grooving type corrosion.
P. A. Attwood, Kees van Gelder, C.D. Charnley   +2 more
openaire   +1 more source

Assessment and comparison of CO2 corrosion predicition models

SPE International Oilfield Corrosion Symposium, 2006
Abstract A number of different CO2 corrosion rate prediction models have been developed for application in oil and gas production systems and are readily available in the literature or as industry standards. These models vary from the empirical models to the more recently developed mechanistic models.
Richard Woollam, Sandra Hernandez
openaire   +1 more source

Inhibition of CO2 Corrosion via Sustainable Geminal Zwitterionic Compounds: Effect of the Length of the Hydrocarbon Chain from Amines

ACS Sustainable Chemistry and Engineering, 2018
Three geminal zwitterionic compounds are synthesized pursuing five parameters of green chemistry: atomic economy, environmental factor, mass intensity, mass reaction efficiency, and carbon efficiency; and evaluated as corrosion inhibitors for carbon ...
Enrique Gómez Juárez, V. Mena-Cervantes, J. Vazquez‐Arenas, G. P. Flores, R. Hernández-Altamirano   +4 more
semanticscholar   +1 more source

Development of a Reference Electrode for Study of Supercritical CO2 Corrosion

Corrosion, 2018
Two methods to prepare tungsten/tungsten oxide as reference electrode for performing electrochemical measurements in H2O-saturated super critical (SC) CO2 phase in the study.
C. Cheng, R. Case, Jing Ning
semanticscholar   +1 more source

High Salt Concentration Effects on CO2 Corrosion and H2S Corrosion

CORROSION 2010, 2010
Abstract The general CO2 corrosion rates of C1018 carbon steel have been measured for NaCl concentrations 3 – 25 wt% at 20°C, pH 4.0, 5.0 and 6.0. The corrosion process was monitored by linear polarization resistance and potentiodynamic sweeps.
Haitao Fang, Bruce Brown, Srdjan Nešić
openaire   +1 more source

Improvement on the CO2 corrosion prediction via considering the corrosion product performance

Corrosion Science, 2023
Cailin Wang, X. Xu, Cuiwei Liu, Xiao Luo, Q. Hu, Rui Zhang, Hongda Guo, Xiao Luo, Y. Hua, Yuxing Li   +9 more
semanticscholar   +1 more source

Inhibited Under-Deposit CO2 Corrosion: Small Particle Silica Sand and Eicosane Paraffin Deposits

Corrosion, 2017
Chemical inhibition in the presence of silica sand deposit has been reported as a cause of severe localized corrosion attack in CO2-saturated brine environments.
Shokrollah Hassani, Jin Huang, Ana Camila Victor, B. Brown, M. Singer   +4 more
semanticscholar   +1 more source

Modes of CO2-Corrosion Damage: Consequences for Corrosion Control Strategies

CORROSION 1996, 1996
Abstract CO2-corrosion damage to C-steel and low-alloy steel may take various forms; the major types being pitting, grooving and uniform attack. In particular for tubular and pressure containing components, the significance of such damage on safety and reliability is dependent on its interaction with operational loads, and the potential ...
T. Sydberger, J.D. Edwards, O. Bjornoy
openaire   +1 more source

Modelling of Co2 Corrosion and Feco3 Formation in Nacl Solutions

Social Science Research Network, 2022
Mustafa M. Alsalem, M. Ryan, A. Campbell, K. S. Campbell   +3 more
semanticscholar   +1 more source

H2S + CO2 Corrosion: Additional Learnings from Field Experience

Corrosion, 2015
The field experience in H2S + CO2 corrosion which was first reported in 20061 has been significantly increased, some of which has been made available in the literature. Several new cases are included in this paper. This experience has been compiled and
M. Bonis, R. MacDonald
semanticscholar   +1 more source