Results 11 to 20 of about 2,164,521 (333)

Comparison of the Stator Step Skewed Structures for Cogging Force Reduction of Linear Flux Switching Permanent Magnet Machines

open access: yesEnergies, 2018
Linear flux switching permanent magnetic (LFSPM) machines, with the armature windings and magnets both on the mover in addition to a robust stator, are a good choice for long stoke applications, however, a large cogging force is also inevitable due to ...
Wenjuan Hao, Yu Wang
doaj   +2 more sources

Design of Small Permanent-Magnet Linear Motors and Drivers for Automation Applications with S-Curve Motion Trajectory Control and Solutions for End Effects and Cogging Force

open access: yesEnergies
This paper designs and fabricates a small-type permanent-magnet linear motor and driver for automation applications. It covers structural design, magnetic circuit analysis, control strategies, and hardware development.
Chia-Hsiang Ho, Jonq-Chin Hwang
doaj   +2 more sources

Minimization of Cogging Force in Fractional-Slot Permanent Magnet Linear Motors with Double-Layer Concentrated Windings

open access: yesEnergies, 2016
Permanent magnet linear motors (PMLMs) with double-layer concentrated windings generally show significant cogging forces due to the introduction of auxiliary teeth for eliminating the end-effect induced phase unbalance, even when the fractional-slot ...
Qian Wang, Bo Zhao, Jibin Zou, Yong Li
doaj   +2 more sources

Cogging force investigation of a free piston permanent magnet linear generator

open access: yesIOP Conference Series: Materials Science and Engineering, 2017
Better performance and higher efficiency of the vehicles can be achieved by using free piston engine, in which the piston is connected directly to the linear generator and waiving of any mechanical means. The free piston engine has the ability to overcome or reduce many of the challenges, such as the carbon dioxide (CO2) emission and fossil fuel ...
I I Abdalla   +5 more
openaire   +2 more sources

Cogging force mitigation techniques in a modular linear permanent magnet motor

open access: yesIET Electric Power Applications, 2016
Modular linear doubly salient permanent magnet motors are well adapted to linear propulsion systems because of their distinct characteristics, such as high efficiency and power density, reduced maintenance and initial cost, low noise and permanent magnet (PM) leakage flux, and fault tolerance capability.
Farid Tootoonchian   +1 more
openaire   +2 more sources

Research on the influence of trapezoidal magnetization of bonded magnetic ring on cogging torque

open access: yesOpen Physics, 2023
In this article, the influence of trapezoidal magnetization method on cogging torque of permanent magnet motor is studied. First, the structure is analyzed by analytical method to explain its mechanism of reducing cogging torque. Then, in order to verify
Zhang Ze   +8 more
doaj   +1 more source

Nonlinear Vibration Analysis of Rotor considering Cogging and Harmonic Effects

open access: yesShock and Vibration, 2021
This paper aims to investigate nonlinear vibration characteristics of rotor system considering cogging and harmonic effects. Firstly, relative permeance with eccentric was established and then corrected by correction factor caused by the cogging effect ...
Shanle Li   +4 more
doaj   +1 more source

Combined methods for torque variation reduction of high-speed FSPM

open access: yesEnergy Reports, 2023
Flux switching permanent magnet machine (FSPM) with six slots and four poles (6/4) shows great potential for high-speed operation. However, the 6/4 FSPM suffers from high cogging torque at no load and loaded torque variation.
Jiayue Zhou, Xi Xiao
doaj   +1 more source

Design and qnalysis of a novel linear transverse flux permanent magnet motor using HTS magnetic shielding [PDF]

open access: yes, 2010
In this paper, a novel linear transverse flux permanent magnet (TFPM) motor is proposed, which can offer higher thrust force, lower cogging force and easier manufacturing than its counterpart. The key is to propose a new C-shaped TFPM motor topology with
Chau, KT, Li, W
core   +1 more source

Comparison of three analytical methods for the precise calculation of cogging torque and torque ripple in axial flux PM machines [PDF]

open access: yes, 2016
A comparison between different analytical and finite-element (FE) tools for the computation of cogging torque and torque ripple in axial flux permanent-magnet synchronous machines is made.
Hannon, Bert   +3 more
core   +3 more sources

Home - About - Disclaimer - Privacy