Results 161 to 170 of about 2,663 (214)

Development of intelligent hybrid controller for torque ripple minimization in electric drive system with adaptive flux estimator: An experimental case study. [PDF]

PLoS One
Kant S, Sreejeth M, Singh M, Devanshu A, Alotaibi MA, Malik H, García Márquez FP.   +6 more
europepmc   +1 more source

Comparative analysis of brushless DC and switched reluctance motors for optimizing off-grid water pumping. [PDF]

Sci Rep
Kumar A, Marwaha S, Manna MS, Marwaha A, Kumar R, Amir M, Bajaj M, Zaitsev I.   +7 more
europepmc   +1 more source

Optimization design and torque performance research of interior permanent magnet synchronous motors. [PDF]

Sci Rep
Niu L.
europepmc   +1 more source

Torque and speed prediction of a brushless direct current motor using nonlinear autoregressive with exogenous inputs and neural network. [PDF]

Sci Rep
Khan MA, Baig DE, Ali H, Albogamy FR.
europepmc   +1 more source

Extracorporeal Blood Pump driven by a Novel Bearingless Split-Tooth Flux-Reversal Motor. [PDF]

IEEE ASME Trans Mechatron
Kant K, Trumper DL.
europepmc   +1 more source

A Survey on Design and Control Methodologies of High- Torque-Density Joints for Compliant Lower-Limb Exoskeleton. [PDF]

Sensors (Basel)
Xu J, Chen S, Li S, Liu Y, Wan H, Xu Z, Zhang C.   +6 more
europepmc   +1 more source

Design and Implementation of a Linear Active Disturbance Rejection Control-Based Position Servo Control System of an Electromotive Valve for Exhaust Gas Recirculation. [PDF]

Sensors (Basel)
Cheng X, Yin J, Li X, Zhou R, Fu C.
europepmc   +1 more source

Cogging Torque Analysis in Permanent Magnet Machines

openaire   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Cogging Torque Reduction by Elementary-Cogging-Unit Shift for Permanent Magnet Machines

IEEE Transactions on Magnetics, 2017
This paper describes a method to reduce cogging torque in permanent magnet (PM) machines by shifting elementary-cogging unit (ECU). The ECU division principle and the feature of cogging torque produced by ECU are also discussed. The proper shift angles for each ECU are deduced according to both fractional and integral slot number per pole, by which any
Jian Gao, Guang Wang, Xiao Liu
exaly   +2 more sources

Minimizing the Influence of Cogging Torque on Vibration of PM Brushless Machines by Direct Torque Control

IEEE Transactions on Magnetics, 2006
This paper applies direct torque control (DTC) to a permanent magnet (PM) brushless machine, which maybe either brushless AC or DC, highlights the difference in its implementation when cogging is considered, and compares the performance which is achieved both with and without a consideration of the cogging torque. It is shown that DTC can automatically
Z Q Zhu
exaly   +2 more sources