Results 101 to 110 of about 145,210 (211)

High-pressure LOX/CH4 injector program [PDF]

Two injector types, either coaxial or impinging elements, for high pressure LOX/CH4 operation with an existing 40K chamber are examined. A comparison is presented.
Kirby, F. M., Wheeler, D. B.
core   +1 more source

Review of Recent Advances in Cold-Sprayed Coatings for Accident-Tolerant Fuel Cladding. [PDF]

Materials (Basel)
Mou Y, Zhou Y, Zhou H, Yang R, Huang J, Tian Y, Wu S, Zhou P, Song M, Han J, Li H.   +10 more
europepmc   +1 more source

Advanced liner-cooling techniques for gas turbine combustors [PDF]

Component research for advanced small gas turbine engines is currently underway at the NASA Lewis Research Center. As part of this program, a basic reverse-flow combustor geometry was being maintained while different advanced liner wall cooling ...
Norgren, C. T., Riddlebaugh, S. M.
core   +1 more source

Spray combustion experiments and numerical predictions [PDF]

The next generation of commercial aircraft will include turbofan engines with performance significantly better than those in the current fleet. Control of particulate and gaseous emissions will also be an integral part of the engine design criteria ...
Bulzan, Daniel L., Chen, Kuo-Huey, Mularz, Edward J.   +2 more
core   +1 more source

Cold-Sprayed Ni and NdFeB-Al Powders Recovery and Reuse. [PDF]

Materials (Basel)
Lamarre JM, Nascimento A, Charbonneau C, Pouliot L, Bernier F.   +4 more
europepmc   +1 more source

Coal pump development phase 3 [PDF]

Techniques for achieving continuous coal sprays were studied. Coazial injection with gas and pressure atomization were studied. Coal particles, upon cooling, were found to be porous and fragile.
Gerbracht, F. G., Kushida, R. O., Mahajan, V., Sankur, V. D.   +3 more
core   +1 more source

Editorial for the Special Issue on Heat and Mass Transfer in Microchannels. [PDF]

Micromachines (Basel)
Xiao X, Zhang X, Zhang L.
europepmc   +1 more source

Gas and ceramic particle velocities for micro-cold spray

Journal of Aerosol Science, 2023
Stephen G. Bierschenk, Michael F. Becker, Desiderio Kovar   +2 more
openaire   +1 more source

Influence of Titanium Content on the Microstructure and Tensile Behavior of Cold-Spray Additively Manufactured Copper-Titanium Composites. [PDF]

Materials (Basel)
Cheng J, Huang J, Li H, Zhang K, Chen T, Lan H, Huang R.   +6 more
europepmc   +1 more source

Spray drying: From a traditional technology to modern biotechnological applications. [PDF]

Int J Pharm X
Milanesi A, Diana G, Candiani A, Sodano A, Rassè P, Foglio Bonda A, Bari E, Torre ML, Segale L, Giovannelli L.   +9 more
europepmc   +1 more source