Results 161 to 170 of about 1,917 (218)
Some of the next articles are maybe not open access.
Materials Science and Technology, 1986
AbstractAn interactive graphic simulator of the cold rolling process has been developed. The rolling pressure model is based upon the Bland–Ford theory and includes the elastic deformations of strip and work rolls. The transverse elastic deformation of the four-high roll system is modelled by a polynomial parametrization of the results from a finite ...
openaire +1 more source
AbstractAn interactive graphic simulator of the cold rolling process has been developed. The rolling pressure model is based upon the Bland–Ford theory and includes the elastic deformations of strip and work rolls. The transverse elastic deformation of the four-high roll system is modelled by a polynomial parametrization of the results from a finite ...
openaire +1 more source
Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 1992
A theory of cold rolling of thin gauge strip is presented which, within the idealizations of homogeneous deformation and a constant coefficient of Coulomb friction, rigorously models the elastic deformation of the rolls and the frictional traction at the interface.
N A Fleck +3 more
openaire +1 more source
A theory of cold rolling of thin gauge strip is presented which, within the idealizations of homogeneous deformation and a constant coefficient of Coulomb friction, rigorously models the elastic deformation of the rolls and the frictional traction at the interface.
N A Fleck +3 more
openaire +1 more source
International Metals Reviews, 1977
A complete review of developments in rolling during the last decade would have to cover thousands of published papers and also much unpublished work; comprehensive coverage would thus become impossible within the confines of a short review. In the earlier review of this series, Ford concentrated on the theory of flat rolling. Books
openaire +1 more source
A complete review of developments in rolling during the last decade would have to cover thousands of published papers and also much unpublished work; comprehensive coverage would thus become impossible within the confines of a short review. In the earlier review of this series, Ford concentrated on the theory of flat rolling. Books
openaire +1 more source
Virtual rolling quality system for cold rolling
Steel Research International, 2010A prototype of virtual rolling quality system for a 4 stands cold rolling process is created. In this system virtual sensors and models are used to calculate quality features based on process information and analyzed history data. The virtual-sensor technology is developed for estimating of hard-to-measure variables and further on to define methods to ...
Larkiola, Jari +3 more
openaire +2 more sources
Polymer-Plastics Technology and Engineering, 1976
Abstract Cold rolling of metals is a well-developed commercial practice. Cold rolling of polymers, on the other hand, is still in its early stages of research and development. It has shown sufficient promise so that it deserves more serious commercial development.
openaire +1 more source
Abstract Cold rolling of metals is a well-developed commercial practice. Cold rolling of polymers, on the other hand, is still in its early stages of research and development. It has shown sufficient promise so that it deserves more serious commercial development.
openaire +1 more source
Journal of Materials Science, 1971
The morphology of unidirectional cold rolled polyethylene was investigated. The techniques of scanning electronmicroscopy, wide angle X-ray diffraction, DTA, and XYZ photographic light scattering were employed. Most of the study was undertaken using low density polyethylene which had been initially cold rolled to an elongation of 100% and then annealed
openaire +1 more source
The morphology of unidirectional cold rolled polyethylene was investigated. The techniques of scanning electronmicroscopy, wide angle X-ray diffraction, DTA, and XYZ photographic light scattering were employed. Most of the study was undertaken using low density polyethylene which had been initially cold rolled to an elongation of 100% and then annealed
openaire +1 more source
Thermomechanical strengthening of rolls for cold rolling
Metallurgist, 1986A. F. Pimenov +4 more
openaire +1 more source