Results 171 to 180 of about 24,740 (298)

Effect of Al Content on the Microstructure and Corrosion Resistance of Low-Pressure Cold-Sprayed Fe-Al Coatings. [PDF]

Materials (Basel)
Liu Y, Jia Z, Zhang Y.
europepmc   +1 more source

Sprayable Polyolefin Sorbents Enabled by Bio‐Solvents for Large‐Scale Oil and Chemical Spill Recovery

ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.
A sprayable POE‐based sorbent formulated with a green solvent blend of α‐pinene, D‐limonene, and p‐cymene enables rapid in situ film formation via solvent evaporation, allowing efficient pollutant capture. The system exhibits high oil uptake (37.3 g g−1) and effectively removes up to 60 mL of VLSFO under simulated marine spill conditions.
Youngmin Choi, Changwoo Nam
wiley   +1 more source

High-performance flexible electronics from organic fluorosilicone/carbon composites for low-temperature wearable sensors. [PDF]

RSC Adv
Ma X, Wang Y, Zhu H.
europepmc   +1 more source

Harnessing Thin‐Film Solid‐State Electrolytes: Enabling Breakthroughs in All‐Solid‐State Batteries

ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.
Schematic illustration highlighting the advantages of transitioning from traditional thick solid‐state electrolytes (SSEs) to thin‐film SSEs. Thinning the electrolyte enables higher ionic conductivity, reduced interfacial polarization, improved flexibility, compact electrode contact, and enhanced energy density, offering a promising pathway toward high‐
Yitao He, Haoyang Cheng, Li Wang, Xiangming He   +3 more
wiley   +1 more source

Influence of Titanium Content on the Microstructure and Tensile Behavior of Cold-Spray Additively Manufactured Copper-Titanium Composites. [PDF]

Materials (Basel)
Cheng J, Huang J, Li H, Zhang K, Chen T, Lan H, Huang R.   +6 more
europepmc   +1 more source

Environmental Thermoeconomic Performance Analysis of Gas Steam Combined Cycle With Different Inlet Air Cooling Technologies

Energy Science &Engineering, EarlyView.
This study establishes an environmental thermoeconomic cost model to investigate the impact of two IAC technologies on the performance of a GSCC from three aspects of energy, economy, and environment. Under arid climate conditions, the SEC technology demonstrates superior performance in terms of cost‐effectiveness and environmental impact.
Zhen Wang, Li Zhang, Yu Ni, Liqiang Duan
wiley   +1 more source

Acceleration of Atmospheric Freeze-Drying of Food: Methods, Implications, Commercialization, and Future Directions. [PDF]

Compr Rev Food Sci Food Saf
Bhatkar NS, Murthy AA, Quek SY, Woo MW.
europepmc   +1 more source

Effect of Ammonium Polyphosphate/Silicate Content on the Postfire Mechanics of Epoxy Glass‐Fiber Composites Using Facile Chocolate Bar‐Inspired Structures

Fire and Materials, Volume 49, Issue 3, Page 329-346, April 2025.
ABSTRACT This study investigates the postfire mechanical properties of epoxy glass‐fiber reinforced composites (EP GFRCs) using increasing concentrations of ammonium polyphosphate (APP) and inorganic silicate (InSi) to modify the char and fire residue.
Sruthi Sunder, Maria Jauregui Rozo, Sneha Inasu, Dietmar Meinel, Bernhard Schartel, Holger Ruckdäschel   +5 more
wiley   +1 more source

Rapid Determination of Several Biogenic Amines in Cold-Chain Fish Samples by Portable Ion Trap Mass Spectrometry with Nano-Electrospray Ionization. [PDF]

Foods
Wu J, Ma X, Wang Z, Wei Y, Liu Y, Men J, Ma W.   +6 more
europepmc   +1 more source

Char Layer Thickness Evolution During Structural Timber Fire Experiment and Final Density Profile

Fire and Materials, EarlyView.
ABSTRACT This paper evaluates several non‐destructive experimental methods for determining the char layer thickness and its density profile in structural timber samples exposed to standard ISO 834 fire curve experiments. Microwave echo pulse, ultrasonic echo pulse, X‐ray computed tomography, and resistance drilling were evaluated.
Fernando Pérez Pérez, Kiarash Tajbakhsh, Joachim Schmid, Robert Zboray, Andrea Frangi   +4 more
wiley   +1 more source