Results 91 to 100 of about 948,514 (304)

Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials

Advanced Engineering Materials, EarlyView.
Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai, Xinrui Sarah Niu, Zhao Qin   +2 more
wiley   +1 more source

Research Progress of Cold Storage Insulation Box in Vaccine Cold Chains

Zhileng xuebao, 2019
One of the major factors in the annual loss of vaccine products is the failure of cold-chain transportation, where the most common piece of equipment used during transport is the cold storage box. The main factors that influence the performance of a cold
Dou Mengke, Liu Baolin, Song Xiaoyan, Chen Zhouqi   +3 more
doaj  

A thermoviscoplastic model with damage for simultaneous hot/cold forging analysis [PDF]

, 2013
A constitutive model is presented for simultaneous hot/cold forming processes of steels. The phenomenological material theory is based on an enhanced rheological model and accounts temperature dependently for nonlinear hardening, thermally activated ...
Bröcker, C., Matzenmiller, A.
core  

Electrochemical Evaluation of Compressed Selective Laser Melted AlSi7Mg and AlSi10Mg Alloys in Chloride Environment

Advanced Engineering Materials, EarlyView.
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin, Samson Dare Oguntuyi, Peter Apata Olubambi   +2 more
wiley   +1 more source

Research on Stirling-type Low-Temperature Cold Storage at -80 ℃

Zhileng xuebao, 2023
The use of -80 ℃ low-temperature cold storage is increasing in blood stations, hospitals, and medical research institutions. Low-temperature cold storage primarily uses traditional cascade refrigeration systems.
Zhang Ankuo, Wu Ming, Feng Yinglong, Yu Wenhui, Xiong Chao, Xie Jing   +5 more
doaj  

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

Advanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira, Marcella Gaute Cavalcante Xavier, Abdoul‐Aziz Bogno, Piter Gargarella, José Eduardo Spinelli   +4 more
wiley   +1 more source

Texture effect on the neutral layer shift and twinning behavior in bending of Mg alloys: Crystal plasticity modeling and experiment

Journal of Magnesium and Alloys
Bending is a crucial operation in the sheet forming of Mg alloys for automotive and aerospace applications. In this work, three kinds of sheets from an AZ31 rolled plate, sheared at 0° (S0), 45° (S45), and 90° (S90) to the rolling direction, were ...
Weijie Ren, Chuan Tan, Renlong Xin, Xianxian Jiang, Huagui Huang, Xianhua Chen, Fusheng Pan   +6 more
doaj   +1 more source

The Value of USDA Situation and Outlook Information in Hog and Cattle Markets [PDF]

This study investigates the impact of six major USDA reports in hog and cattle markets: Cattle; Cattle on Feed; Cold Storage; Hogs and Pigs; Livestock, Dairy, and Poultry Outlook (LDPO); and World Agricultural Supply and Demand Estimates (WASDE). A TARCH-
Good, Darrel L., Irwin, Scott H., Isengildina, Olga   +2 more
core   +1 more source

Synthesis of a Novel Thermoresponsive S53P4 Bioactive Glass Extract–Poloxamer 407 Injectable Hydrogels: Assessment of Biocompatibility and Antimicrobial Properties

Advanced Engineering Materials, EarlyView.
This study investigates innovative thermoreversible hydrogels derived from S53P4 bioactive glass extracts to aid in the healing of infected diabetic foot wounds. These injectable gels, which gel at body temperature, release beneficial ions and remain stable over time.
Marian G. Vargas Guerrero, Adrian Stiller, Alex Nygård, Matej Krivulka, Lars Galema, Erwin Peters, Jimmy Lucchesi, Peter Uppstu, Leena Hupa, Jacobus J. C. Arts   +9 more
wiley   +1 more source

Design and Research of a New Cold Storage: The Phase-Temperature Storage (PTS) to Reduce Evaporator Frosting

Foods
This paper introduces a novel cold storage: phase-temperature storage, which is characterized by its distinctive coupling jacket structure that connects the sub-storehouse units to the main storehouse.
Lihua Duan, Yanli Zheng, Yunbin Jiang, Wenhan Li, Limei Li, Bin Liu, Bin Li, Xihong Li   +7 more
doaj   +1 more source