Results 91 to 100 of about 779,507 (290)
The Canadian Journal of Chemical Engineering, EarlyView.Abstract The objective of this work is to demonstrate that the inclusion of an up‐flow anaerobic sludge bed (UASB reactor) within an industrial wastewater treatment plant reduces the plant's investment and operating costs compared to a system based solely on conventional complete‐mix activated sludge (CMAS), operating under the same design principles ...
Juan Manuel Morgan‐Sagastume +1 more
wiley +1 more source
Large-eddy simulation of kerosene spray combustion in a model scramjet chamber
, 2010 Large-eddy simulation (LES) of kerosene spray combustion in a model supersonic combustor with cavity flame holder is carried out. Kerosene is injected through the ceiling of the cavity.
Zhang, Man +3 more
core +1 more source
The Canadian Journal of Chemical Engineering, EarlyView.Abstract This study examines the microwave‐assisted catalytic pyrolysis (MACP) of individual and blended textiles (cotton, polyester, nylon 6) using ZnO and a ZnO/natural zeolite catalyst. In a custom‐built microwave reactor operated at 500°C, 1 kW power, and a 15‐min residence time, textile wastes were pyrolyzed.
Peyman Alizadeh +3 more
wiley +1 more source
Modeling the processes of combustion products formation in the coal-dust flame
Physical Sciences and Technology, 2018 In this paper deals with development and application the numerical model for solution of processes at combustion chamber of the industrial boiler. The combustion chamber of the BKZ-75 boiler installed at Shakhtinskaya Thermal Power Plant (Karaganda ...
A. Askarova +4 more
doaj
MATEC Web of Conferences, 2018 Resistance is The article presents the results of the research of a charge swirl motion influence on working process, engine parameters and NOx emissions of a spark ignition premixed natural gas engine. The charge swirl motion was organized by tangential
Patsey Pavel, Galyshev Yuriy
doaj +1 more source
A novel bubbling fluid bed reactor for the autothermal pyrolysis of waste plastics
The Canadian Journal of Chemical Engineering, EarlyView.Abstract A new pilot‐scale fluidized bed reactor operated under continuous conditions was developed and tested for the thermal pyrolysis of high‐density polyethylene (HDPE). The study focused on assessing the reliability and operability of the system under different operating conditions (400–550°C), while monitoring mass and energy balances, product ...
Khadija Olivia Ogoula Igouwe +4 more
wiley +1 more source
Heat losses in internal combustion engines [PDF]
, 1989 Bibliography: leaves 119-121.This thesis deals with the effects of cooling and heat losses in internal combustion engines. The object of this work was to examine and research various cooling concepts and methods to reduce heat loss to engine coolant ...
Clarke, Ralph Henry
core +1 more source
Role of Lewis centres on ethanol dehydrogenation over the Cu‐Cr/γ‐Al2O3 system
The Canadian Journal of Chemical Engineering, EarlyView.Cu–Cr interactions on alumina enhance Lewis acid site density, boosting selectivity towards ethanol dehydrogenation products. Soft coke formation on copper and Cu–Cr sites drives deactivation, shifting the reaction towards unwanted dehydration products.
Sakun Preedavijitkul +7 more
wiley +1 more source
, 2015 Cold start for diesel engine is an important issue due to high amount of unburned hydrocarbon and combustion instability. In order to mitigate the problem, fundamental understanding about effects of engine operating condition on spray and combustion ...
Kim, Kihyun +3 more
core +1 more source
Frontiers in MaterialsIn order to compensate for the limitations of traditional temperature measurement methods, glass plates were installed on both sides of the single-dome combustion chamber test piece, and two CCD cameras observed the combustion flame in the furnace from ...
Miaomiao Chen +3 more
doaj +1 more source