Results 1 to 10 of about 368,015 (310)
Investigation on Fuel Quality and Combustion Characteristics of Blended Fuel (Biomass and Lignite) Derived from Low-Temperature Co-Upgradation [PDF]
MoleculesCo-combustion is regarded as an effective means for high-efficiency utilization of low-quality fuels. However, low-quality fuel has problems such as low energy density and high water content.
Ning Liu +4 more
doaj +2 more sources
Co-pyrolysis and combustion characteristics of polylactic acid and acrylonitrile-butadiene-styrene: insights into interactions, kinetics and synergistic effects [PDF]
Frontiers in ChemistryPolylactic acid (PLA) and acrylonitrile-butadiene-styrene (ABS) are the most commonly used filaments in 3D printing. To enable filament materials to withstand higher stresses, PLA and ABS are often blended (PLA/ABS).
Xujuan Wu +4 more
doaj +2 more sources
Study on slagging characteristics and prevention of biomass briquette [PDF]
E3S Web of Conferences, 2021 It is a high efficiency，energy-saving and emission reduction measure to replace coal with biomass briquette fuel in a layer combustion furnace, but in the combustion process, the serious slagging problem has been restricted the promotion of biomass fuel.
Xiaoping Ren +5 more
doaj +1 more source
Analysis on Combustion Instability Characteristics of Model Swirl Combustor With Gas Fuel
发电技术, 2022 Combustion instability is easy to occur under lean combustion of gas turbine. Analyzing and predicting the characteristics of unstable combustion is of great significance to ensure the normal operation of combustion chamber. The flame describing function
HAO Jiangang +4 more
doaj +1 more source
Авіаційно-космічна техніка та технологія, 2021 A method has been developed for selecting the geometric characteristics of the front and the length of the direct-flow combustion chamber. Afterburner combustion chambers are of the ramjet type and are used for a short-term increase in the thrust of a ...
Дмитрий Викторович Козел
doaj +1 more source
Consideration on the reaction mechanism of thallium oxide as a combustion catalyst of PM2.5
Studies in Science and Technology, 2021 Seven types of oxide ion conductive ceramics (ZrO2)0.92(Y2O3)0.08, (CeO2)0.8(Gd2O3)0.2, La2Zr2O7, (Bi2O3)0.75(Y2O3)0.25, (ZrO2)0.90(Sc2O3)0.10, La9.7Si6O26.55, and La0.8Sr0.2Ga0.8Mg0.115Co0.085O3 were composited with Tl2O3, which has excellent carbon ...
Susumu Nakayama +3 more
doaj +1 more source
Combustion Characteristics of CAI Combustion with Alcohol Fuels [PDF]
SAE Technical Paper Series, 2010 <div class="section abstract"><div class="htmlview paragraph">Due to its potential for simultaneous improvement in fuel consumption and exhaust emissions, controlled autoignition (CAI) combustion has been subject to continuous research in the last several years.
Tongroon, M, Zhao, H
openaire +2 more sources
Nihon Kikai Gakkai ronbunshu, 2022 The component proportion of gasoline varies depending on the mining time of crude oil, the mining place, and so on. Because it has effects on the engine performance and emission characteristics, studying the effects of the fuel properties on combustion ...
Takasumi DOI, Tadashige KAWAKAMI
doaj +1 more source
Zhejiang dianli, 2022 Heating surface overtemperature often occurs in a 1 030 MW ultra-supercritical boiler unit that uses blended low-moisture Australian coal. Through a comparison test of blended coal burning， the paper concludes that there is no evident correlation between
ZHU Qingguo +6 more
doaj +1 more source
CAI combustion with methanol and ethanol in an air-assisted direct injection SI engine [PDF]
, 2008 Copyright © 2009 SAE International. This paper is posted on this site with permission from SAE International. Further use of this paper is not permitted without permission from SAECAI combustion has the potential to be the most clean combustion ...
Brouzos, NP, Li, Y, Zhao, H
core +1 more source