Results 221 to 230 of about 34,828 (258)
Some of the next articles are maybe not open access.

Achieving wide-band common-mode rejection in differential amplifiers

Proceedings of the IEEE, 1970
A design method is presented for achieving wide-band common-mode rejection (CMR) in discrete or integrated differential amplifiers. The method, which is supported by experiment, shows that there is an optimum (noninfinite) value for the tail impedance, and that infinite rejection can be achieved at any frequency even in the asymmetrical case.
C. Sripaipan, W.H. Holmes
openaire   +2 more sources

Differentially tunable varactor with built-in common-mode rejection

The 2002 45th Midwest Symposium on Circuits and Systems, 2002. MWSCAS-2002., 2003
A differentially tunable MOS varactor with enhanced intrinsic common-mode noise rejection is proposed and analyzed. Using a complementary topology the C-V characteristics of two MOSFETs are arranged to sum under differential excitation and to roughly cancel under common-mode excitation.
S.K. Magierowski   +2 more
openaire   +1 more source

An APF-OCC Strategy for Common-Mode Current Rejection

IEEE Transactions on Industry Applications, 2016
This paper proposes a DSP-based one-cycle control (OCC) strategy for a shunt active power filter (APF), which is able to reject common-mode currents caused by common-mode voltages. The proposed strategy is based on an OCC rectifier control, which utilizes an input resistance control to set up dc-link voltage and achieve a unity power factor as well as ...
Alberto Soto Lock   +3 more
openaire   +1 more source

Common-mode rejection ratio and the ‘Early-intercept’ voltage

International Journal of Electronics, 1977
The improvement in low frequency common-mode rejection that results from the replacement of the tail resistor of a simple BJT differential amplifier by a current source is shown to be related to a recently discussed parameter—the ‘ Early-intercept ’ voltage.
B.L. HART, R. W.J. BARKER
openaire   +1 more source

Deferentially-fed band-pass filter with common mode rejection

2018 22nd International Microwave and Radar Conference (MIKON), 2018
A design of bandpass filter with the utilization of balanced lines is shown. A broadside stripline technology is proposed for its physical realization. A good in-band common mode rejection is obtained due to the chosen filter topology and realization.
Konrad Janisz   +4 more
openaire   +1 more source

Inductive debris detection using common-mode rejection

IET Conference Proceedings, 2022
M. Zhao, W. Hong, B. Chen, H. Li, C. Lu
openaire   +1 more source

Film acoustically-coupled transformer with increased common mode rejection

The Journal of the Acoustical Society of America, 2008
The film acoustically-coupled transformer (FACT) has a first and second decoupled stacked bulk acoustic resonators (DSBARs). Each DSBAR has a lower film bulk acoustic resonator (FBAR), an upper FBAR atop the lower FBAR, and an acoustic decoupler between them FBARs.
openaire   +1 more source

Common-mode rejection-ratio analysis using the adjoint network

IEEE Transactions on Circuits and Systems, 1974
The computational effort involved in differential-amplifier common-mode rejection-ratio (CMRR) calculations may be reduced by using the adjoint network to obtain the network sensitivities required for the CMRR determination.
openaire   +1 more source

Current-input differential amplifiers with high common-mode rejection

1969 IEEE International Solid-State Circuits Conference. Digest of Technical Papers, 1969
This paper will describe a new differential amplifier, the dual of conventional amplifiers, whose output is proportional to the differential-mode input current, while common-mode currents are rejected. High common-mode rejection can be maintained over wide bandwidths.
openaire   +1 more source

Colorectal cancer statistics, 2023

Ca-A Cancer Journal for Clinicians, 2023
Rebecca L Siegel   +2 more
exaly  

Home - About - Disclaimer - Privacy