Results 281 to 290 of about 49,233 (340)

Direct Ink Writing Additive Manufacturing of Polyimide Aerogels. [PDF]

Gels
Chen B, Jiang Q, Jiang J.
europepmc   +1 more source

Enhanced high voltage insulation performance of HTV silicon rubber nanocomposites filled with nano-TiO₂ for outdoor applications. [PDF]

Sci Rep
Rehman AU, Khan MS, Khattak A, Ahmad N, Imran K, Khan Y, Alkhalid KH.   +6 more
europepmc   +1 more source

IDD-DETR: Insulator Defect Detection Model and Low-Carbon Operation and Maintenance Application Based on Bidirectional Cross-Scale Fusion and Dynamic Histogram Attention. [PDF]

Sensors (Basel)
Chen W, Li S, Han X.
europepmc   +1 more source

Unraveling of electrical conductivity for nanocomposites containing carbon black: a new insight into tunneling resistance. [PDF]

Sci Rep
Abdollahi F, Mohammadi M, Zare Y, Naqvi M, Rhee KY, Park SJ.   +5 more
europepmc   +1 more source

Understanding the Interfacial Behavior of Cycloaliphatic-like Epoxy Resin with Optical Fibers: Insights from Experiments and Molecular Simulations. [PDF]

Materials (Basel)
Fu J, Lin Z, Luo J, Zheng Y, Liu Y, Cao B, Yin F, Wang L.   +7 more
europepmc   +1 more source

Durability of crosslinked polydimethylsyloxanes: the case of composite insulators

, 2008
Florence Delor-Jestin et al
openalex   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Polyphenylsulfone-hBN Composite Insulation

2020 IEEE 3rd International Conference on Dielectrics (ICD), 2020
The goal of this work was to develop and characterize high-temperature, thermally conductive electrical insulation to improve thermal management in high power density electric motors. Polyphenylsulfone (PPSU) films were extruded with up to approximately 24 wt% of either micro-sized hexagonal boron nitride (hBN) or a mixture of micro-and nano-sized hBN ...
Tiffany Williams, Baochau Nguyen, Witold Fuchs   +2 more
openaire   +1 more source

Electronic charge exchange at insulator-insulator interface in insulating composites

Proceedings of 1994 4th International Conference on Properties and Applications of Dielectric Materials (ICPADM), 2002
The charge exchange at the insulator-insulator interface in insulating composites is affected by the direction of the carrier transport and carrier species. In this paper the charge exchange process at the PS-PMMA interface was discussed on the basis of asymmetric photoconduction and contact charging.
A. Kawamoto, Y. Suzuoki, T. Mizutani, T. Ikejiri, M. Ieda   +4 more
openaire   +1 more source

Composite Post Insulators

2013
In contrast to composite long rods, composite post insulators are subjected mainly to loads which act perpendicular to the longitudinal axis of the insulator and thus produce bending stresses over the cross-section of the insulator. As a result of this bending load, composite post insulators use FRP rods of substantially greater diameter compared to ...
Konstantin Papailiou, Frank Schmuck
openaire   +1 more source