Results 151 to 160 of about 238,845 (361)
3D Bioprinting of Thick Adipose Tissues with Integrated Vascular Hierarchies
Advanced Functional Materials, Volume 35, Issue 12, March 18, 2025.An advanced 3D bioprinting technique is used here to create thick adipose tissues with a central, vessel and extensive branching. The construct is made using alginate, gelatin and collagen‐based bioinks. Flow through the complex vessel network is demonstrated as well as its successful integration with a femoral artery following implantation in a rat ...
Idit Goldfracht +5 more
wiley +1 more source
Full load shop testing of 18,000-hp gas turbine driven centrifugal compressor for offshore platform service: Evaluation of rotor dynamics performance [PDF]
The results for in-plant full load testing of a 13.4 MW (18000 HP) gas turbine driven centrifugal compressor are presented and compared to analytical predictions of compressor rotor stability.
Kirk, R. G., Simpson, M.
core +1 more source
Calculation of the Dimensions of Axial Flow Compressor for the Gas Turbine Power Plant
, 1951 Izumi IGUTI
openalex +2 more sources
Advanced Functional Materials, EarlyView.Joule‐assisted nanotherapeutic urethral stent harnesses a smart, biodegradable magnesium stent to orchestrate spatiotemporal theragenerative therapy for urethral strictures. Magnetically induced Joule heating enables on‐demand drug release and bacterial ablation, while simultaneously guiding urothelial regeneration.
Yuhyun Na +15 more
wiley +1 more source
Analysis of fully stalled compressor [PDF]
An analysis yields a model for energy transfer in compressor stages operating in the closed-throttle condition. The derivation indicates that three geometry parameters (hub/tip ration, aspect ration, and rotor blade setting angle) influence the values of
Rostafinski, W.
core +1 more source
Discussion: “Closed Systems for Testing Compressors” (Johnson, R. M., 1956, Trans. ASME, 78, pp. 1677–1682) [PDF]
, 1956 T. O. Kuivinen
openalex +1 more source
Advanced Functional Materials, Volume 35, Issue 12, March 18, 2025.The ultraselective H2S detection of the ZIF‐L/SnS2 heterostructure is demonstrated. The introduction of 2‐dimensional (2D) breathable ZIF‐L results in a substantial increase in H2S selectivity attributable to the molecular sieving effect, which impedes the permeation of gases with large kinetic diameters and high polarity.
Soo Min Lee +7 more
wiley +1 more source
Ultrahigh Piezoelectricity in Truss‐Based Ferroelectric Ceramics Metamaterials
Advanced Functional Materials, Volume 35, Issue 12, March 18, 2025.By leveraging the unique combination of polarization direction and loading state, ultrahigh piezoelectricity is achieved through careful tuning of the relative density and scaling ratio in truss‐based ferroelectric metamaterials. This approach enables the simultaneous realization of extremely high piezoelectric constants and ultralow dielectric ...
Jiahao Shi +6 more
wiley +1 more source
T55-L-712 turbine engine compressor housing refurbishment-plasma spray project [PDF]
A study was conducted to assess the feasibility of reclaiming T55-L-712 turbine engine compressor housings with an 88 wt percent aluminum to 12 wt percent silicon alloy applied by a plasma spray process.
Leissler, George W., Yuhas, John S.
core +1 more source