Results 11 to 20 of about 110,149 (273)

Finite element analysis of RC buildings subjected to blast loading

Ain Shams Engineering Journal, 2022
In this paper, the response of reinforced concrete buildings subjected to blast loading under variable mass of TNT and different statical system will be discussed. The study was carried out using the finite element program (ABAQUS) by using two different
Mennatullah Talaat, Ebtisam Yehia, Sherif A. Mazek, Magdy M.M. Genidi, Alaa G. Sherif   +4 more
doaj   +1 more source

Structural Behavior of Reinforced Lightweight Concrete Slabs

Diyala Journal of Engineering Sciences, 2022
This paper presents an exploration of choosing the optimum density for concrete that achieves the best structural performance for two-way slabs made of concrete with fine aggregate in different proportions less than the ratio used in ordinary concrete ...
Yahyia M. Hameed , Murtada A. Ismael
doaj   +1 more source

Parametric study for influence of input parameters for analysis of fibre reinforced concrete slab-soil interaction [PDF]

, 2018
For geotechnical engineering and design of foundation elements of structures is important to properly determine the stress-deformation state of the subsoil.
Marcaliková, Zuzana, Neuwirthová, Zdeňka, Čajka, Radim   +2 more
core   +1 more source

Dynamic response of concrete pavement structure with asphalt isolating layer under moving loads

Journal of Traffic and Transportation Engineering (English ed. Online), 2014
A three-dimensional finite element model (3D FEM) is built using ABAQUS to analyze the dynamic response of a concrete pavement structure with an asphalt isolating layer under moving loads. The 3D model is prepared and validated in the state of no asphalt
Jianmin Wu, Jiaping Liang, Sanjeev Adhikari   +2 more
doaj   +1 more source

Fibrous Reinforced Concrete Slabs

University of Khartoum Engineering Journal, 2022
The paper presents the results of a theoretical and an experimental work performed at the KhartoumUniversity, Civil Engineering Department Structure lab. The work aimed to obtain knowledge concerning theinfluence of steel fibers on the behaviour of reinforced concrete slabs. A comparative study was conductedtheoretically and experimentally.
Anwar Abdalla Elamin, El-Niema I. El-Niema   +1 more
openaire   +1 more source

The Design of a semi-prefabricated LVL-concrete composite floor [PDF]

, 2012
This paper describes the design of a novel semi-prefabricated LVL-concrete composite floor that has been developed in New Zealand. In this solution, the floor units made from LVL joists and plywood are prefabricated in the factory and transported to the ...
Fragiacomo, Massimo, Yeoh, David
core   +3 more sources

Fatigue Tests of Concrete Slabs Reinforced with Stainless Steel Bars

Advances in Materials Science and Engineering, 2018
Experimental studies on fatigue behavior of reinforced concrete slab with stainless steel rebar and carbon steel rebar have shown that, at the same reinforcement ratio, the slope of the deflection-cycle number curves of stainless steel-reinforced ...
Guoxue Zhang, Ying Zhang, Yangyang Zhou
doaj   +1 more source

Reliability verification of an existing reinforced concrete slab [PDF]

, 2018
The submitted contribution provides background information on the principles accepted in the CEN Technical Specification (TS). The application of the verification methods provided in the TS is clarified by an assessment of a reinforced concrete ...
Holický, Milan, Jung, Karel
core   +1 more source

Load Capacities of Steel and Concrete Composite Bridge Deck Slab with Haunch

Advances in Civil Engineering, 2017
An innovative steel and concrete composite bridge deck slab using bent bars and epoxy as shear connectors was proposed. Four slab specimens with different types of concrete were fabricated and tested to study the load capacities of positive and negative ...
Xiaoqing Xu, Yuqing Liu
doaj   +1 more source

Shear-Bond Behaviour of Profiled Composite Slab Incorporated with Self-Compacted Geopolymer Concrete

Applied Sciences, 2022
Composite slab systems have become increasingly popular over the last few decades because of the advantages of merging the two building materials, profiled steel sheets and concrete.
Mohamed Heweidak, Bidur Kafle, Riyadh Al-Ameri   +2 more
doaj   +1 more source