Results 61 to 70 of about 34,228 (221)
Polymer International, EarlyView.The 100% recycling of optimal polycarbonate/acrylonitrile–butadiene–styrene/poly(methyl methacrylate) (PC/ABS/PMMA) blends, identified through the mixture design, over multiple successive cycles provides valuable insights into their life cycle. Subsequently, chemical, rheological, thermal and mechanical characterizations will be carried out to evaluate
Rahma Ezzeddine +3 more
wiley +1 more source
Case Studies in Thermal EngineeringIn order to study heat release rate and flue gas generation during residual coal in goaf combustion, a cone calorimeter was used to research on combustion characteristics of bituminous coal under different heat radiation flux conditions.
Wenzhou Du +6 more
doaj +1 more source
Aromatic vs. Aliphatic Hyperbranched Polyphosphoesters as Flame Retardants in Epoxy Resins
Molecules, 2019 The current trend for future flame retardants (FRs) goes to novel efficient halogen-free materials, due to the ban of several halogenated FRs. Among the most promising alternatives are phosphorus-based FRs, and of those, polymeric materials with complex ...
Jens C. Markwart +5 more
doaj +1 more source
Monitoring of historical structural materials with computed tomography
Structural Concrete, EarlyView.Abstract Computed tomography (CT) is an excellent tool to solve certain engineering problems connected to material science (such as sulfate swelling, internal degradation due to freezing, and alkali silicate swelling) and to understand specific processes (frost peeling, acid action).
Kristóf Csorba +5 more
wiley +1 more source
Recent Run II QCD Results from DO
, 2004 We present recent QCD results from the D0 experiment at the Fermilab Tevatron Collider in pp-bar collisions at sqrt(s)=1.96 TeV. Results are presented for the inclusive jet and dijet cross sections, a measurement of dijet azimuthal decorrelations ...
Wobisch, Markus
core +1 more source
Journal of Vinyl and Additive Technology, Volume 31, Issue 2, Page 339-355, March 2025.Effecft of co‐doping polyaniline with phosphoric acid and phytic acid on the heat release rate of polyethylene. Abstract Polyolefins, such as polyethylene (PE), are highly flammable and electrically insulative, limiting their applicability. The study explored the flame‐retardancy and electrical conductivity of PE/polyaniline (PE/PANI) nanocomposites ...
Akeem Adisa +4 more
wiley +1 more source
Jet energy calibration at the LHC
, 2015 Jets are one of the most prominent physics signatures of high energy proton proton (p-p) collisions at the Large Hadron Collider (LHC). They are key physics objects for precision measurements and searches for new phenomena.
Schwartzman, Ariel
core +1 more source
Fire and Materials, Volume 50, Issue 3, Page 318-333, April 2026.ABSTRACT Materials and products age with time and their properties change. It is known that, for example, the mechanical strength may be deteriorated from ageing. To understand the ageing effect on the fire behaviour of materials and products is important to maintain the safety level of the construction or application.
Anna Sandinge +3 more
wiley +1 more source
Combustion Characteristics of Car Components Using Cone-Calorimeter [PDF]
Journal of Korean Society for Atmospheric Environment, 2009 The combustion characteristics of car components have been investigated, The combustion parameters like heat release rate, smoke production, yield of carbon dioxide and carbon monoxide and mass loss rate were analyzed by cone-calorimeter for representative samples (seat, carpet, headrest, rubber mat, dash board and electric wire) collected from a used ...
Eun-Young Park, Duck-Shin Park
openaire +1 more source
Reconstruction and identification of hadronic decays of tau leptons in ATLAS [PDF]
, 2014 Hadronically decaying tau leptons are of prime importance in numerous physics analyses in ATLAS. The spectrum of the possible applications of hadronically decaying tau leptons reaches from Standard Model measurements, including Higgs searches, to ...
Zinonos, Zinonas
core