Results 111 to 120 of about 669,241 (267)
Arthritis Care &Research, EarlyView.Objective This study aimed to characterize cannabis product choices (cannabinoid content and formulation) among patients with rheumatologic conditions and their associations with patient factors, patient‐reported perceived side effects, and positive impacts.
Susan Zhang +10 more
wiley +1 more source
Arthritis Care &Research, EarlyView.Objective Although the definition of a gout flare is well established, the state of gout flare resolution has not yet been defined. This study aimed to explore patients’ experiences and perceptions of gout flare resolution. Methods Semistructured interviews were conducted with 24 people with gout, guided by open‐ended questions exploring their ...
Sarah Stewart +5 more
wiley +1 more source
Arthritis Care &Research, Accepted Article.Objective To evaluate utility of an artificial intelligence (AI) health coach for systemic sclerosis (SSc) self‐management and identify patterns associated with participant engagement. Methods We conducted a mixed‐methods study in which an AI health coach, powered by a large language model (LLM), was used to support self‐management for SSc.
Nirali Shah +4 more
wiley +1 more source
Tibio talar contact stress: An experimental and numerical study. [PDF]
J Orthop, 2020 Filardi V.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Comparison of the contact stress between the sensor and real polyethylene insert in total knee arthroplasty: a finite element analysis. [PDF]
Ann Transl Med, 2020 Song SJ, Kim KI, Park CH.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Effects of contact stress on patellarfemoral joint and quadriceps force in fixed and mobile-bearing medial unicompartmental knee arthroplasty. [PDF]
J Orthop Surg Res, 2020 Kwon HM +4 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.This article presents the NFDI‐MatWerk Ontology (MWO), a Basic Formal Ontology‐based framework for interoperable research data management in materials science and engineering (MSE). Covering consortium structures, research data management resources, services, and instruments, MWO enables semantic integration, Findable, Accessible, Interoperable, and ...
Hossein Beygi Nasrabadi +4 more
wiley +1 more source