Results 11 to 20 of about 3,972,229 (347)
Measurement Quality in Analysis—Guidelines and Software Tools
Proceedings, 2023 Measurement quality is about fulfilling analytical requirements, which should be based on the intended use of the results. Within the European Union, environmental requirements can be set in a directive based on the maximum allowable concentration of a ...
Bertil Magnusson
doaj +1 more source
LIMITATIONS ON QUANTUM CONTROL [PDF]
International Journal of Modern Physics B, 2002 In this note we give an introduction to the topic of Quantum Control, explaining what its objectives are, and describing some of its limitations.
Solomon, Allan I., Schirmer, Sonia G.
openaire +2 more sources
Reduction of Feedback Availability Limits Self-Control Effects
Frontiers in Sports and Active Living, 2022 A growing body of research has demonstrated that providing learners with self-control over aspects of the learning environment facilitates the learning of a motor skill.
Aaron D. von Lindern +1 more
doaj +1 more source
On limits of contact tracing in epidemic control.
PLoS ONE, 2021 Contact tracing and quarantine are well established non-pharmaceutical epidemic control tools. The paper aims to clarify the impact of these measures in evolution of epidemic.
Tomasz Piasecki +2 more
doaj +1 more source
Setting process control chart limits for rounded-off measurements
Heliyon, 2023 Measurements can often be imprecise and subjected to rounding-off. Typically, this rounding-off is ignored and assumed to have little to no effect. However, when the measuring scale step is not negligible, it may affect statistical control tools such as ...
Ran Etgar, Sarit Freund
doaj +1 more source
Limits on atomic qubit control from laser noise
npj Quantum Information, 2022 Technical noise present in laser systems can limit their ability to perform high fidelity quantum control of atomic qubits. The ultimate fidelity floor for atomic qubits driven with laser radiation is due to spontaneous emission from excited energy ...
Matthew L. Day +4 more
doaj +1 more source
Estimation of change limits (deltacheck) in clinical laboratory
Advances in Laboratory Medicine, 2021 Change limits, more commonly called delta check, are those in which a change in a patient’s measured result in relation to their corresponding preceding measurement is suspected of being erroneous and should be considered as a doubtful result. The aim of
Castro-Castro Maria-José +1 more
doaj +1 more source
Innovative Business Development. Statistical Control of Processes in Six Sigma
Мир новой экономики, 2018 Introduction. The success and competitiveness of any enterprise are facilitated by the introduction of innovative approaches and continuous improvement of technological processes. In addition, it is not enough simply to modernize the equipment.
Denis A. Zhevnov
doaj +1 more source
Sliding Mode Control With Limits on the Control Signal and Linear State Combinations
IEEE Access, 2022 In this paper the sliding mode controller is designed using the reaching law approach. The system model considers the time-varying uncertainties and the unknown, external disturbances.
Marek Jaskula, Piotr Lesniewski
doaj +1 more source
Testing the limits: Ryanair/Aer Lingus and the boundaries of merger control [PDF]
, 2016 Between the summer of 2007 and the autumn of 2015 Ryanair made repeated and determined attempts either to acquire the entirety of Aer Lingus or to defend the acquisition of a minority shareholding in the company.
Furse, Mark
core +1 more source