Results 201 to 210 of about 66,477 (313)

Composite membranes comprising of polymeric and molecular amines embedded in poly(vinyl alcohol) matrices to facilitate CO2/H2 separation

open access: yesThe Canadian Journal of Chemical Engineering, EarlyView.
Polymeric and molecular amines embedded in hygroscopic matrices to facilitate CO2 transport for CO2/H2 separation. Abstract This work dealt with composite membranes comprising of polyvinylamine (PVAm) and triethylenetetramine (TETA) embedded in poly(vinyl alcohol) (PVA) for CO2/H2 separation via facilitated transport of CO2, where polymeric and ...
Steve Yijie Hu, Kean Wang, Xianshe Feng
wiley   +1 more source

In‐situ asphaltene capture with iron oxide nanoparticles in steam‐assisted gravity drainage (SAGD) for improved recovery and partial upgrading of bitumen

open access: yesThe Canadian Journal of Chemical Engineering, EarlyView.
Key improvements obtained by incorporating nanoparticles into a lab‐scale SAGD process configuration. The bar plots show enhanced oil recovery, reduced viscosity, and increased asphaltene adsorption in nanoparticle‐assisted scenarios compared with conventional SAGD.
Luis Prada   +6 more
wiley   +1 more source

An Estimation of the Heat Load Distribution on the Divertor Target Using the CSD Model

open access: yesContributions to Plasma Physics, EarlyView.
ABSTRACT Handling the heat load on the divertor target is a critical issue in the design of fusion reactors. Estimating the heat load, supported by computationally efficient simulations with varying design parameters, provides valuable input to high‐level design discussions and the development of design guidelines.
Kazuhiro Yamada   +4 more
wiley   +1 more source

Heat Load Mitigation Studies in the W7‐X Stellarator Experiment

open access: yesContributions to Plasma Physics, EarlyView.
ABSTRACT During the experiments at the stellarator Wendelstein 7‐X (W7‐X) with fully water‐cooled plasma‐facing components (PFC), including carbon‐fiber composite (CFC) divertor targets with a thermal load capability of 10 MW/m2, high performance was achieved.
Dirk Naujoks   +11 more
wiley   +1 more source

Implementation of the E×B and Grad‐B Drift in the EMC3 Code and Verification Using the Method of Manufactured Solutions

open access: yesContributions to Plasma Physics, EarlyView.
ABSTRACT Effective management of particle and power exhaust is essential for fusion reactor operation, requiring accurate 3D modeling of divertor physics. The EMC3 code is a well‐established Monte Carlo tool for plasma transport in stellarator edge regions, but until now lacked E×B$$ E\times B $$ and diamagnetic drifts.
Ruben De Wolf   +5 more
wiley   +1 more source

Home - About - Disclaimer - Privacy