Results 71 to 80 of about 788,119 (288)
Is economic convergence in New Member States sufficient for an adoption of the Euro? [PDF]
The New European Member States (NMS) are expected to adopt the euro as soon as they fulfil the Maastricht criteria, which means that their nominal convergence has been achieved; but the question is: should those new European members adopt the euro as ...
Marie-José Rinaldi-Larribe
core
On the equivalence of Eulerian and Lagrangian variables for the two-component Camassa-Holm system
, 2017 The Camassa-Holm equation and its two-component Camassa-Holm system generalization both experience wave breaking in finite time. To analyze this, and to obtain solutions past wave breaking, it is common to reformulate the original equation given in ...
A Bressan +26 more
core +1 more source
Convergence Criteria for Dynamic Integer Systems
, 2021 Criteria are presented for testing whether every trajectory of a dynamic integer system converges to the same fixed ...
openaire +2 more sources
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
The global financial crisis and its implications on the convergence of Romania with the economic and monetary union [PDF]
The international financial crisis has affected the new member States of the European Union as well, for which the convergence criteria represent the economic test of evaluation of a degree of economic preparation, in order to participate in the third ...
Marioara AVRAM, Veronel AVRAM
core
Convergence Criteria for Axial Compressor Flow Calculations
, 2018 Computational fluid dynamics is routinely used in the turbomachinery industry to aid in the design of axial flow compressors. The predictive capability of such codes is related to the quality of the numerical convergence of the flow solutions they produce.
Vekinis, Andrew, Longley, John
openaire +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
The Maastricht convergence criteria and economic growth in the EMU [PDF]
The Maastricht convergence criteria are partially based on the theory of optimum currency areas and costs-benefits analysis of the creation of a single currency area as the EMU foundation.
Slawomir I. BUKOWSKI
core
Evaluating Energy Absorption Performance of Filled Lattice Structures
Advanced Engineering Materials, EarlyView.Maximum stress must be considered to robustly evaluate energy absorber designs. This approach was applied to compare all types of absorbers in a single Ashby diagram and determine the utility of filling lattice voids with a second material. High‐performance fillers can improve the performance of lattices that are limited by buckling or catastrophic ...
Christian Bonney +2 more
wiley +1 more source
EURO CHALLENGES AND PERSPECTIVES FOR ROMANIA [PDF]
Annals of the University of Oradea: Economic Science, 2010 The process of preparation and adoption of the European single currency is one of the most important challenges that Romania has to face in the first decade as a full time member of the European Union.
Sandu Carmen
doaj