Results 21 to 30 of about 132,920 (161)

A General Approach in Optimization of Heat Exchangers by Bio-Inspired Artificial Intelligence Methods

open access: yesEnergies, 2019
The paper introduces the artificial intelligence (AI) approach as a general method for the design and optimization study of heat exchangers. Genetic Algorithms (GA) and Artificial Neural Networks (ANN) are applied in the paper.
Jaroslaw Krzywanski
doaj   +1 more source

Comparative Investigation on the Thermophysical Property and System Performance of R1234yf

open access: yesEnergies, 2023
In this paper, an experimental study of R1234yf replacing R22 in window air conditioning was carried out. The optimum types of capillary tubes and the charge amount were obtained, and the system performance of the window air conditioning charged with ...
Gailian Li   +3 more
doaj   +1 more source

THE FACTORS INFLUENCING QUALITY OF STRUCTURE OF WORKPIECES PROCESSED ON THE VACUUM LINE «MODULTHERM 7/1»

open access: yesЛитьë и металлургия, 2017
Results of metallographical observations of structural constituent of carburized cases and a core of gears after thermochemical treatment on a vacuum line «ModulTherm 7/1» made by corporation «ALD Vacuum Technologies GmbH» are given.
S. P. Rudenko   +2 more
doaj   +1 more source

Perhitungan Cooling Capacity Yang Dibutuhkan Pada Kapal Tanker 17500 LTDW Cooling Capacity Calculations Required On Tanker Ship 17500 LTDW

open access: yesOtopro, 2018
Jurnal ini menjelaskan tentang perhitungan cooling capacity yang dibutuhkan pada Kapal Tanker 17500 LTDW, perhitungan cooling capacity bertujuan untuk mengetahui daya compressor yang dibutuhkan pada system pendingin.
Syeihan Syahrul Syah   +2 more
doaj   +1 more source

Comparison of R134a and R516A’s Performance at Different Air Velocities in Two Evaporator Ejector Cooling System

open access: yesHittite Journal of Science and Engineering, 2023
This study aims experimentally to investigate the performance parameters of R134a and the alternative R516A refrigerant in two evaporator ejector cooling system (DEES) at different air velocities of evaporator#1.
Mahmut Cüneyt Kahraman   +2 more
doaj   +1 more source

Analysis of the Energy Efficiency of the Air Conditioning System Based on Absorption Refrigeration Machine with Connection of Heat Pump and Solar Collectors [PDF]

open access: yesProblems of the Regional Energetics, 2023
This article proposes and analyzes a circuit solution for providing heat supply to the generator of an absorption refrigeration machine (AHM) in centralized air conditioning systems using a heat pump unit (HPU) and solar collectors (SOL).
Mereutsa E.V., Sukhikh A.A.
doaj   +1 more source

DETERMINE OF PROJECT COOLING CAPACITY OF THE AIR CONDITIONING SYSTEM IN ACTUAL CLIMATE CONDITIONS AND BY DIFFERENT METHODS

open access: yesАвіаційно-космічна техніка та технологія, 2019
The cold output for the heat-moisture treatment of ambient air in air conditioning systems depends on its parameters (temperature and relative humidity), which vary significantly during operation.
Євген Іванович Трушляков   +5 more
doaj   +1 more source

ASSESSMENT OF THE COOLING CAPACITY OF THE REFRIGERATION UNIT OF A MOTOR VEHICLE

open access: yesIntelligence. Innovations. Investment, 2022
Abstract. The need for isothermal vans for the transportation of perishable goods and cargo is currently relevant in our country. An acute problem is also the evaluation of refrigerators in order to determine the most important indicator of the quality of the insulation of the van — the heat transfer coefficient and the efficiency (cooling capacity) of
A. A. Petrov, N. A. Kuzmin
openaire   +1 more source

Innovative Turbine Intake Air Cooling Systems and Their Rational Designing

open access: yesEnergies, 2020
The efficiency of cooling ambient air at the inlet of gas turbines in temperate climatic conditions was analyzed and reserves for its enhancing through deep cooling were revealed. A method of logical analysis of the actual operation efficiency of turbine
Andrii Radchenko   +4 more
doaj   +1 more source

Study on the Development of Small Cooling Module System for Scrubber to Improve Toxic Gas Treatment Efficiency

open access: yes대한환경공학회지, 2021
Objectives : Manufacturing-based production facilities are required to install dust collection devices for air pollution prevention facilities. In particular, manufacturing-based companies need low-power hazardous gas treatment devices.
Dong Sub Lee, Jin Hee Kim
doaj   +1 more source

Home - About - Disclaimer - Privacy