Results 41 to 50 of about 132,920 (161)

Experimental Research on Heat Transfer Performance of Single Tube Multi-Row Finned Tube Evaporator

open access: yesZhileng xuebao, 2022
In this study, the heat balance method stipulated in the ASHRAE 75–77 standard is adopted to solve the problems of low heat exchange efficiency and high consumption of pipes in traditional tube evaporators used in food cold chain systems.
Peng Jie   +9 more
doaj  

The Research of Cooling Load and Cooling Capacity Calculation Methods of Spinning Workshop

open access: yesProcedia Environmental Sciences, 2011
AbstractThis article takes a spinning workshop of Xi’an region in summer as an example, calculated and contrasted each part cooling load of spinning workshop by using cooling load coefficient method and steady calculation method, it comes to a conclusion that the results of two algorithms are little different and using steady calculation method is ...
Suqian, Yan   +3 more
openaire   +1 more source

General Approach for Composite Thermoelectric Systems with Thermal Coupling: The Case of a Dual Thermoelectric Cooler

open access: yesEntropy, 2015
In this work, we show a general approach for inhomogeneous composite thermoelectric systems, and as an illustrative case, we consider a dual thermoelectric cooler. This composite cooler consists of two thermoelectric modules (TEMs) connected thermally in
Cuautli Yanehowi Flores-Niño   +2 more
doaj   +1 more source

Radiative cooling capacity on Earth

open access: yes
Four ...
Wang, Cunhai   +5 more
openaire   +2 more sources

STUDI COOLING CAPACITY KAPAL CEPAT RUDAL 60 METER (STUDI KASUS PADA KCR 60 BATCH DI PT PAL INDONESIA)

open access: yesOtopro, 2019
Perkembangan dunia perkapalan maupun dunia maritim harus diimbangi dengan peningkatan mutu alat transportasi, terutama untuk alat transportasi laut. Pada alat transportasi tersebut beban pendinginan pada tiap ruangan perlu dilakukan perhitungan secara ...
Bobby Xaverius   +2 more
doaj   +1 more source

A method of cooling capacity enhancement of ceiling panel [PDF]

open access: yesE3S Web of Conferences, 2019
The cooling energy demand in the buildings is quite large nowadays and it will increase rapidly in the near future. Therefore, capacity of existing cooling devices must be increased. In this paper surface corrugation as a method of capacity enhancement of ceiling panels is theoretically investigated.
Wojtkowiak Janusz, Amanowicz Łukasz
openaire   +2 more sources

Effect of Film Cooling on Turbine Capacity

open access: yesJournal of Engineering for Gas Turbines and Power, 2009
This paper describes a method that allows the effect of film cooling on the capacity of a turbine to be computed. The model is based on fundamental cooling performance parameters and is applicable to situations in which a mainstream flow is displaced by a partially mixed film cooling layer.
openaire   +2 more sources

COOLING CAPACITY OF AIR CONDITIONING SYSTEM ACCORDING TO CURRENT HEAT LOAD

open access: yesАвіаційно-космічна техніка та технологія, 2019
The efficiency of the outdoor air conditioning systems application depends on how full the installed cooling capacity is applied, that is, with a more complete load and for as long as the possible yearly duration in actual climatic conditions.
Євген Іванович Трушляков   +5 more
doaj   +1 more source

Cooling Capacity and Energy Performance of Open-Type Ceiling Radiant Cooling Panel System with Air Circulators

open access: yesEnergies, 2020
Ceiling radiant cooling panel (CRCP) systems are being increasingly applied to commercial buildings due to their high thermal comfort level and energy efficiency.
Mi-Su Shin, Ji-Su Choi, Kyu-Nam Rhee
doaj   +1 more source

CAPACITY OF THE INTERSTAND COOLING UNIT IN HOT ROLLING PROCESS

open access: yesActa Metallurgica Slovaca, 2014
The aim of the paper was to improve the economy of rolling mill production and to extend the control range of cooling capacity of the accelerated cooling unit by choosing the optimal dimensions of the cooling chamber. The object of research was the interstand cooling unite for accelerated cooling of the hot-rolled products of round section in the line ...
Vladimir L. Brovkin   +6 more
openaire   +4 more sources

Home - About - Disclaimer - Privacy