Results 121 to 130 of about 1,952,754 (311)
Comparing low rate copper formulations against Phythophthora infestans in potatoes [PDF]
, 2009 Between Dutch organic growers the late blight problems lead to discussions in which a temporary registration of copper products is also suggested. Some growers do not want any pesticides at all, while others see that biological potatoes from abroad are ...
Bus, C.B.
core +1 more source
Temperature dependence of spin polarization in ferromagnetic metals using lateral spin valves
, 2013 A high reproducibility in the performance of cobalt/copper and permalloy/copper lateral spin valves with transparent contacts is obtained by optimizing the interface quality and the purity of copper.
Casanova, Fèlix +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Nickel‐based alloys are widely used in high‐temperature applications due to their excellent mechanical strength and oxidation resistance. However, properties such as high‐temperature strength and pronounced work‐hardening make them difficult to machine.
Soheil Rooein +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
"Asiatic" copper in New Kingdom Egypt [PDF]
, 2015 This work presents a combination of Lead Isotope Analysis ( LIA ) and ancient Egyptian texts and depictions in order to describe the history of the ox -hide copper ingots presence in Egypt , which w ere called by the Egyptians “Asiatic copper”.
Giménez Izquierdo, Francisco Javier
core +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Current use and legal status of crop protection inputs [PDF]
, 2018 This deliverable presents the results of the survey carried out in the frame of Tasks 3.1. and Task 5.1 in the Horizon 2020 Project Organic PLUS. A common table/questionnaire for both tasks was used in order to map the use of contentious inputs linked to
Andrivon, Didier +10 more
core
Sol–Gel Derived Polymer Precursors for Stereolithography of ZrC
Advanced Engineering Materials, EarlyView.ZrC is a critical material target for extreme temperature conditions. This report describes a protocol for preparing ZrC ceramics via stereolithography and examines the impact of the polymer matrix on carbothermal reduction and mechanical stability of 3D printed ZrC.
Charles J. Rafalko +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study investigates thermo‐chemical processes during high‐temperature testing of two commercial MgO‐C brick grades, one containing 47.5 wt.% MgO‐C recyclate. Using ETV, DTA/TG‐MS, XRD, and SEM/EDS/EBSD, mechanisms such as carbothermal reduction of magnesia, impurity incorporation into the secondary MgO surface layer, and calcium‐rich phase ...
Alexander Schramm +6 more
wiley +1 more source