Rapidly Solidified High‐Strength Invar 36 Prepared by Planar‐Flow Melt Spinning
The Invar 36 alloy was rapidly solidified using the planar‐flow melt‐spinning technique. Ribbon samples with thicknesses ranging from 20 to 160 mm were produced. As the grain size of the ribbon decreased to sub‐micron levels, the hardness increased by more than 2 times.
Bekir Akgül, Mehmet Kul
wiley +1 more source
Small-Size Graphene-Enabled Corrosion-Resistant Ultra-Thin Copper Foils Fabricated by Direct-Current Electrodeposition. [PDF]
Yu Z +9 more
europepmc +1 more source
Tracking Battery Microstructural Degradation Through Directional Thermal Transport Signatures
In lithium‐ion batteries, heat conduction varies between the through‐plane and in‐plane directions because of the cell's layered structure. Therefore, cell degradation influences thermal conductivity in each direction uniquely due to detailed microstructural and compositional changes.
Mohammad Shoghi Tekmedash +6 more
wiley +1 more source
Hydrothermal Fabrication of Low-Dimensional CuO Nanosheets for Enhancing Carbon Reduction Product Selectivity. [PDF]
Chu W +8 more
europepmc +1 more source
Preparation and Properties of Nanostructured GaN-Reinforced Cu Matrix Composites. [PDF]
Bai Y, Ge H, Peng Y.
europepmc +1 more source
Assessment of Physical Workload and Maximum Working Capacity among Workers of Metallurgy Factories Processing Aluminum in Howrah District of West Bengal. [PDF]
Biswas D +4 more
europepmc +1 more source
Synthesis, Sintering, and Characterization of Composites. [PDF]
Guo B, Mu X, Zhang H, Cheng X.
europepmc +1 more source
Fungal Bioleaching for Metal Recovery: Recent Progress and Technological Advances. [PDF]
Soares AR, Xu X, Baltazar MDPG, Yin WB.
europepmc +1 more source
Nitrogen Regulation and Its Chemical State in FeCr17Mn12Mo3.5N Powders Based on High-Pressure Nitriding. [PDF]
Jiao X +7 more
europepmc +1 more source

