Results 41 to 50 of about 62,383 (277)
Karl Popper and the Mechanisms of Hydrogen Embrittlement
Advanced Engineering Materials, EarlyView.Representation of the beginning of loss of ductility rather than embrittlement. Small concentrations of hydrogen in a diffusible form within iron are well‐established to harm the mechanical integrity of steels. There are theories that attempt to explain the pernicious role of hydrogen.
H. K. D. H. Bhadeshia
wiley +1 more source
RESEARCH ON DEGRADATION CORROSIVE ENVIRONMENT OF SOME STEELS USED IN MANUFACTURING MINING EQUIPMENT. MECHANICAL TESTS [PDF]
Fiabilitate şi Durabilitate, 2017 Simultaneous action of mechanical stress variables and the corrosive environment leads to the deterioration of structures made of steel or of other metallic materials, a process called fatigue in corrosive environment or corrosion fatigue, which has ...
Florin CIOFU, Alin NIOAŢĂ,
doaj
Influence of Atmospheric Corrosion on the Service Life of Steel Sheets
Communications, 2006 The paper analyses the influence of the duration of atmospheric corrosion on basic mechanical and fatigue properties of steel sheet 2.16-4.46 mm thick, made of low-carbon steel with higher atmospheric corrosion resistance.
Marian Bursak, Jan Michel
doaj +1 more source
Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys
Advanced Engineering Materials, EarlyView.Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak +3 more
wiley +1 more source
Analysis of the effect of bending, fatigue, erosion-corrosion and tensile stresses on HVOF coating of metallic surfaces [PDF]
, 2006 The aim of the present study was to evaluate the bending, fatigue, tensile stresses and erosion-coiTosion characteristics o f HVOF thermally sprayed Inconel-625 powder coatings when deposited on three different metallic surfaces: (a) plain stainless ...
Al Fadhli, Hussain
core
Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A
Advanced Engineering Materials, EarlyView.The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han +5 more
wiley +1 more source
Modelling the role of non metallic inclusions on the anisotropic fatigue behaviour of forged steel [PDF]
, 2011 Forged components are known to show high cyclic and monotonic mechanical properties. This is mainly due to a better compactness and a finer microstructure introduced by the forming process. However, this good mechanical behaviour is sometimes a source of
D. Bellett +7 more
core +1 more source
Advanced Engineering Materials, EarlyView.The present study investigates recycling of NiTi shape memory alloys via vacuum induction melting. An ingot was synthesized from elemental Ni and Ti and subjected to three subsequent remelting cycles. Remelting increases process durations and impurity levels and adversely affects microstructures and functional properties.
Sakia Sophia Noorzayee +7 more
wiley +1 more source
Enhanced Strength and Corrosion Resistance of Ti‐13Nb‐12Ta‐10Zr‐4Sn Alloy by Aging Treatment
Advanced Engineering Materials, EarlyView.This work systematically investigates the effect of aging treatment on mechanical properties and corrosion behavior of vacuum arc‐melted Ti‐13Nb‐12Ta‐10Zr‐4Sn alloy. Owing to the increased α″ martensite, strength and corrosion resistance were significantly enhanced by aging treatment.
Yuhua Li +5 more
wiley +1 more source
Experimental and theoretical studies of corrosion fatigue in a high strength steel. [PDF]
, 1995 The present work consists of both experimental and theoretical aspects of corrosion fatigue in a high strength steel. Fatigue tests were conducted under fully reversed shear loading in an aerated 0.6M NaC1 solution at pH6, for a silico-manganese ...
Wu, Xiao Dong
core