Results 71 to 80 of about 62,383 (277)
A study of fatigue crack propagation in quenched and tempered and controlled rolled HSLA steels. [PDF]
, 1987 A range of HSLA steels reflecting the two major processing routes, quench and tempering and controlled rolling, have been tested in fatigue to assess their potential wider application in the offshore Industry.
Callister, D. R.
core
Advanced Functional Materials, EarlyView.The active role of KCl as a neutral electrolyte enables switching the selectivity on a Cu organic framework from C1 to C2+ products during electrocatalytic CO2 reduction. ABSTRACT We introduce a copper‐nicotinate (Cu‐NA) framework as a halogenide‐stabilized Cu+/Cu0 pre‐catalyst for electrocatalytic CO2 reduction with high C2+ selectivity in a “neutral”
Anirudha Shekhawat +11 more
wiley +1 more source
Materials Research Express, 2023 The aim of the current research is to examine the tribological, corrosion and mechanical properties of AISI 316L stainless steel without and with Al _2 TiO _5 surface coating.
J Jagadesh Kumar +4 more
doaj +1 more source
Advances in Magnesium‐Based Thermoelectrics: A Critical Review
Advanced Materials, EarlyView.Magnesium‐based thermoelectric materials have emerged as promising candidates for low‐to‐mid‐temperature energy conversion due to their abundance, low cost, and competitive performance. This review summarizes recent advances in Mg3X2, MgAgSb, and Mg2X systems, covering transport mechanisms, fabrication strategies, stability challenges, and device ...
Li‐Min Zhang +5 more
wiley +1 more source
Cailiao Baohu, 2022 With the aim of studying the fatigue crack propagation rate law and corrosion mechanism of 60Si2Mn， a commonly used material for high-speed track ballastless railway fastener clips in coastal environment，a neutral salt spray chamber was used to simulate the marine environment.
openaire +1 more source
, 2022 1 S.The application of aluminium alloys for safety relevant structural components of vehicles requires a thorough qualification of alloys as well as components. Corrosion and fatigue properties have to be assessed in advance.
Grimm, Jochen +4 more
core
Statistical assessment of multiaxial HCF criteria at the grain scale [PDF]
, 2014 Multiaxial high cycle fatigue modeling of materials is an issue that concerns many industrial domains (automotive, aerospace, nuclear, etc.) and in which many progress still remains to be achieved.
PALIN-LUC, Thierry +5 more
core +1 more source
Advanced Materials, EarlyView.Ultrathin lithium metal anodes (≤15 µm) offer a promising route to high‐energy‐density batteries due to their high capacity and low potential. This review presents design principles for ultrathin Li, evaluates fabrication strategies, and discusses challenges in liquid and solid‐state cells.
Cheng Wang +9 more
wiley +1 more source
Corrosion Fatigue of 17-4pH Stainless Steel in a Simulated Sea Water Solution
Journal of Advanced Materials in Engineering, 2019 Since martensitic precipitation hardened 17-4pH stainless steel has been widely used in corrosive environments, evaluation of its corrosion fatigue behavior is important. In this research, after microstructural studies, mechanical, corrosion, fatigue and
M. Ghasemian Malakshah +3 more
doaj
Mechanical and metallurgical properties of two-layered diamalloy 4010 and 2002 HVOF coating [PDF]
, 2011 Diamalloy 4010, which is iron/molybdenum blend, is resistive to wear and Diamalloy 2002 is resistive to corrosion and wear. However, combination of these powders in layered structure, may offer advantages over the individual powders.
AL-Shehri, Yasser Abdullah
core