Results 41 to 50 of about 126,344 (318)
Corrosion resistance of composite nickel-AlO deposits
, 1999 The corrosion resistance of composite nickel electrodeposits with alumina embedded in the nickel matrix prepared in sulfate and chloride bath has been studied. As corrosion environment salt spray and nitric acid solution have been tested.
P. Vassiliou +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Journal of Materials Research and Technology, 2023 The improvement of corrosion resistance for sintered Nd-Fe-B magnets is usually focused on the modification of grain boundary phase. The main phase is similarly a key point to enhance corrosion resistance. In this work, a novel sintered Nd-Fe-B magnet is
Yaping Wu +9 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study explored how effective nickel aluminide coatings are obtained in providing oxidation resistance applied to the Inconel 738 alloy, modeling with diffusion models. In the present study, kinetics and thermal behavior of the Inconel 738 alloy were studied by the low‐temperature thermoreactive aluminizing process, which was carried out at 625°C ...
Gozde Celebi Efe +4 more
wiley +1 more source
Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres
Advanced Engineering Materials, EarlyView.This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann +3 more
wiley +1 more source
Research on the Chloride Ion Corrosion Resistance of Cu-Sb-Added Low-Carbon Steel
MetalsThe corrosion resistance of low-carbon steel and two new low-alloy, corrosion-resistant steels containing Cu-Sb and Cu was studied in a simulated seawater environment.
Yuanyu Chen +3 more
doaj +1 more source
mSphere, 2023 Corrosion inhibitors, including zinc orthophosphate, sodium orthophosphate, and sodium silicate, are commonly used to prevent the corrosion of drinking water infrastructure. Metals such as zinc are known stressors for antibiotic resistance selection, and
Lee K. Kimbell +5 more
doaj +1 more source
Control of Magnesium Alloy Corrosion through the Use of Engineered Intermetallics [PDF]
, 2014 The low density and high relative strength of Mg alloys means they can offer engineering benefits over steels or Al alloys. However, the susceptibility of Mg alloys to corrosion has limited their exploitation and restricted their use to more benign ...
Pidcock, Andrew
core
Effect of Oxygen Content on Surface and Subsurface Integrity During Turning of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.This study examines how oxygen content in the ambient atmosphere affects the surface and subsurface properties of Ti–6Al–4V during turning. Results show that oxygen does not influence surface roughness. However, machining in an extremely high vacuum‐adequate atmosphere increases surface hardness by up to 7.8% and induces compressive residual stresses ...
Benjamin Bergmann +3 more
wiley +1 more source
Research Progress of Resistance Probe Corrosion Monitoring Technology [PDF]
Cailiao BaohuIn this paper，the resistance probe corrosion monitoring system and its monitoring principle were introduced.The current research progress of resistance probe corrosion monitoring technology， both domestically and internationally， was reviewed.The ...
HU Jiezhen, CENG Junhao, DENG Peichang, WU Jingquan, LAN Wenjie, LIN Guodong
doaj +1 more source