Results 1 to 10 of about 2,785 (68)

Effects of fin corrugation and tube geometry on the airside performance of fin-and-tube heat exchangers - Part I; dry surface

Journal of Thermal Science and Technology, 2021
For a cooling or heating coil of a building air conditioning system, large diameter tubes (over 12.7 mm) with wave fins are frequently used. Furthermore, there have been attempts to apply oval tubes to the heating or cooling coils.
Nae-Hyun KIM
doaj   +1 more source

Experimental behavior based on effective slab width acting as a flange with supporting steel beams in composite floors with openings

Fracture and Structural Integrity, 2022
An experimental study with many variables was carried out to investigate the effective width of simply supported composite beams (T and L sec. beams) with and without slab opening.
Magdy Khalaf, Ashraf El-Shihy, El-Sayed El-Kasaby, Ahmad Youssef Civil Engineering Dept., Faculty of Engineering, Benha University, Benha, Egypt.   +3 more
doaj   +1 more source

Analysis of the influence of corrugated steel thickness on the damage characteristics and explosion resistance of corrugated steel-concrete composite structure

Case Studies in Construction Materials, 2023
A three-dimensional refined numerical simulation model of corrugated steel-concrete slab composite structure under contact explosion load was established by using FEM-SPH coupling method to explore the anti-explosion performance of corrugated steel ...
Kelei Cao, Qiaofeng Fu, Jianwei Zhang, Haifeng Li, Wenchang Ma, Sherong Zhang, Haiping Ge, Kaicheng Yu   +7 more
doaj   +1 more source

A Comparison of Two Artificial Intelligence Approaches for Corrugated Board Type Classification

Engineering Proceedings, 2023
Corrugated board is an environmentally friendly, commonly used packing material. Its basic structure consists of two liners and a flute between them. The mechanical properties and strength of the corrugated board depend not only on the constituent papers
Maciej Rogalka, Jakub Krzysztof Grabski, Tomasz Garbowski   +2 more
doaj   +1 more source

An experimental investigation on the airside performance of fin-and-tube heat exchangers having corrugated louver fins - Part II; wet surface

Journal of Thermal Science and Technology, 2020
In this study, two kinds of corrugated louver fin-and-tube heat exchangers – one having one corrugation per row and the other having two corrugations per row – were tested under wet condition, and the results were compared with those of the standard ...
Nae-Hyun KIM
doaj   +1 more source

Efisiensi Kapasitas Lentur Beton Pracetak (U-Ditch) Dengan Model Dinding Corrugated

Rekayasa Sipil, 2020
This study discusses to analyze the flexural capacity and efficiency of the corrugated U-Ditch type with dimensions of 50x50 cm to the normal U-Ditch type.
Erwin Syaiful Wagola, Muhammad Tharik Kemal   +1 more
doaj   +1 more source

Analysis of energy absorption characteristics of corrugated top beams of anti-impact hydraulic supports

Alexandria Engineering Journal, 2022
To enhance the inferior energy-absorption performance of a hydraulic support during coal mine rock burst, which leads to failure and damage, a framework including a kind of corrugated laminated energy-absorbing component on the top beam of the hydraulic ...
Chenghu Guo, Jun Mao, Miao Xie
doaj   +1 more source

An experimental investigation on the airside performance of fin-and-tube heat exchangers having corrugated louver fins - Part I; dry surface

Journal of Thermal Science and Technology, 2020
Corrugated louver fin, which has louvers on wavy surface, may be a promising mean to augment the air-side heat transfer of fin-and-tube heat exchangers. However, only limited prior studies are available.
Nae-Hyun KIM
doaj   +1 more source

The impact of the corrugated absorber shape on the performance of a hemispherical solar still for water desalination: an experimental study

Applied Water Science, 2023
Solar stills utilization has received great interest in arid isolated regions. In this study, experimental approaches have been investigated to prove the impact of the corrugated absorber shape on the hemispherical solar still performance. Four geometric
Abd Elnaby Kabeel, Mohammed El Hadi Attia, Abdelkader Bellila, Wael M. El-Maghlany, Mohamed Fayed, Abdelkader Saad Abdullah, Iham F. Zidane   +6 more
doaj   +1 more source

Implementation of the CMOS MEMS Condenser Microphone with Corrugated Metal Diaphragm and Silicon Back-Plate

Sensors, 2011
This study reports a CMOS-MEMS condenser microphone implemented using the standard thin film stacking of 0.35 μm UMC CMOS 3.3/5.0 V logic process, and followed by post-CMOS micromachining steps without introducing any special materials.
Ming-Chuen Yip, Weileun Fang, Jhyy-Cheng Liou, Li-Che Chen, Ming-Yi Wang, Shaoyi Wu, Li-Chi Tsao, Tsung-Min Hsieh, Chien-Hsing Lee, Chien-Hsin Huang   +9 more
doaj   +1 more source