Results 21 to 30 of about 123,561 (298)
Lateral projection as a possible explanation of the nontrivial boundary dependence of the Casimir force [PDF]
, 2000 We find the lateral projection of the Casimir force for a configuration of a sphere above a corrugated plate. This force tends to change the sphere position in the direction of a nearest corrugation maximum.
A. Lambrecht +29 more
core +2 more sources
Wave-Blocking Characteristics of Corrugated Plates under Explosion
Shock and Vibration, 2020 Corrugated-board explosion-proof wall is the main means to prevent explosion shock wave damage, and it is important to study the effect of different corrugated plates on the shock wave.
Guoliang Yang, Shuai Feng, Wenjia Huang
doaj +1 more source
Case Studies in Thermal Engineering, 2022 The use og internal corrugated tubes with varying Reynolds numbers (Re) at a constant wall heat flux, we examine the effects of mixing secondary, spiral, and swirl flows on heat transfer and pressure drop. Furthermore, varying flow analysis is applied to
Ahmed Ramadhan Al-Obaidi +2 more
doaj +1 more source
Energies, 2023 The stability of the casing is a crucial prerequisite for implementing the in situ high-temperature steam injection method in oil shale reservoirs. In order to address the issues of substantial expansion, concentrated thermal stresses, and susceptibility
Siqi Ren +4 more
doaj +1 more source
Development of a Sinusoidal Corrugated Dual-Axial Flexure Mechanism for Planar Nanopositioning
Actuators, 2022 Taking advantage of the concurrent stretching and bending property of corrugated flexure hinges, a sinusoidal corrugated flexure linkage was proposed and applied for the construction of a corrugated dual-axial mechanism with structural symmetry and ...
Yuhan Niu +4 more
doaj +1 more source
COMPARATIVE STUDY OF THE THERMO-CONVECTIVE BEHAVIOR OF A TURBULENT FLOW IN A RECTANGULAR DUCT IN THE PRESENCE OF THREE PLANAR BAFFLES AND/OR CORRUGATED (WAVED) [PDF]
Journal of Engineering Science and Technology, 2018 This study numerically examines the behaviour of a two-dimensional turbulent flow of air in a rectangular pipe with three flat or corrugated baffles. A realizable k-ε turbulence model is used and the conservation equations are solved by the finite volume
HAMIDOU BENZENINE +3 more
doaj
Effect of controlled corrugation on capillary condensation of colloid-polymer mixtures [PDF]
, 2013 We investigate with Monte Carlo computer simulations the capillary phase behaviour of model colloid-polymer mixtures confined between a flat wall and a corrugated wall.
Fortini, Andrea, Schmidt, Matthias
core +2 more sources
Engineering and Applied Science Research, 2021 This paper presents a 3D simulation of turbulent flow and heat transfer behaviors in a five-start corrugated tube having depth ratios, DR = 0.02-0.16 and constant pitch ratio, PR = 1.0 0 and the Reynold number ranging from 5000 to 20,000.
Narin Siriwan +5 more
doaj
Quantitative Nanofriction Characterization of Corrugated Surfaces by Atomic Force Microscopy
, 2003 Atomic Force Microscopy (AFM) is a suitable tool to perform tribological characterization of materials down to the nanometer scale. An important aspect in nanofriction measurements of corrugated samples is the local tilt of the surface, which affects the
A. Podestà +16 more
core +1 more source
Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres
Advanced Engineering Materials, EarlyView.This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann +3 more
wiley +1 more source