Results 1 to 10 of about 898,512 (189)

Generalized Coupled-Line All-Pass Phasers [PDF]

open access: yesIEEE Transactions on Microwave Theory and Techniques, 2015
Generalized coupled-line all-pass phasers, based on transversally-cascaded (TC), longitudinally-cascaded (LC) and hybrid-cascaded (HC) coupled transmission line sections, are presented and demonstrated using analytical, full-wave and experimental results. It is shown that for N commensurate coupled-line sections, LC and TC phasers exhibit N group delay
Gupta, S   +4 more
openaire   +9 more sources

Cross-Coupled Line Bandpass Filter Based on Modified Parallel-Coupled Line Structure

open access: yesJurnal Elektronika dan Telekomunikasi, 2022
This paper presents a study of a narrow bandwidth of the bandpass filter with a cross-coupled line structure. This structure was designed to have a good filter selectivity with the transmission zeros and a simple design.
Fajri Darwis   +7 more
doaj   +2 more sources

Crosstalk tolerance analysis of coupled-line structures using least square-support vector machine technique [PDF]

open access: yesScientific Reports, 2023
In this paper, crosstalk sensitivity analysis of a microwave coupled-line structure due to the fabrication imperfections is investigated using Least Square-Support Vector Machine (LS-SVM) method.
Mohammad G. H. Alijani   +1 more
doaj   +2 more sources

Directional microwave coupled-line couplers with high lateral coupling level

open access: yesДоклады Белорусского государственного университета информатики и радиоэлектроники, 2021
Classic сoupled-line couplers with a high lateral coupling level by type of directivity are counterdirectional. Restrictions on their synthesis are imposed by the gap between transmission lines, which must be extremely small (tens of microns), the ...
I. A. Fanyaev
doaj   +1 more source

A Novel Analytical Design Technique for a Wideband Wilkinson Power Divider Using Dual-Band Topology

open access: yesSensors, 2021
In this paper, a novel analytical design technique is presented to implement a coupled-line wideband Wilkinson power divider (WPD). The configuration of the WPD is comprised of three distinct coupled-line and three isolation resistors.
Asif I. Omi   +4 more
doaj   +1 more source

Wideband Highly-Selective Bandpass Filtering Branch-Line Coupler

open access: yesIEEE Access, 2022
This paper presents a novel design of a wideband highly-selective bandpass filtering branch-line coupler (FBLC). By integrating a coupled microstrip line, and an open-ended stub at each port of a single-section BLC, bandpass filtering characteristics ...
Rusan Kumar Barik   +2 more
doaj   +1 more source

Design of microstrip coupled-line bandpass filter

open access: yesHeritage and Sustainable Development, 2021
This project contains basic information, design, 3D projection, simulation, and analysis of Microstrip Bandpass Filter. The filter was composed of the feed lines connected to the two ports with the parallel coupled lines between them.
Mubina Sasic, Sehabbedin Taha Imeci
doaj   +1 more source

Design of Quad-Band Rat-Race Coupler for GSM/WiMAX/WLAN/Satellite Applications [PDF]

open access: yesRadioengineering, 2021
In this communication, a novel quad-band rat-race coupler (RRC) is developed for GSM/WiMAX/WLAN/Satellite applications. A conventional RRC is converted to exhibit quad-band operation by using a quad-band microstrip-line (QBML).
A. A. Althuwayb
doaj  

Broadband Equal-Split Directional Couplers Composed of Cascade- and Tandem-Connected Coupled-Line Sections Having Unequal Lengths

open access: yesIEEE Access, 2021
A new concept of broadband equal-split coupled-line directional couplers is proposed. The proposed couplers are based on coupled-line sections, all having the same coupling coefficient, and feature frequency characteristics similar to the ones obtained ...
Kinga Gawel   +5 more
doaj   +1 more source

Low-Noise Voltage Controlled Oscillator with Coupled Microstrip Lines of Different Lengths

open access: yesИзвестия высших учебных заведений России: Радиоэлектроника, 2020
Introduction. Coupled two- or three-wire microstrip lines are often used to reduce a phase noise of voltage-controlled oscillators (VCOs). Unfortunately, the phase noise was not optimized depending on the lengths of a three-wire coupled microstrip lines ...
Aleksander V. Baranov
doaj   +1 more source

Home - About - Disclaimer - Privacy