Results 91 to 100 of about 731,464 (195)
Protein expression on Cr resistant microorganism using electrophoresis method [PDF]
Abstrak. Fatmawati U, Suranto, Sajidan. 2009. Ekspresi protein pada mikroorganisme resisten Cr dengan metode elektroforesis. Nusantara Bioscience 1: 31-37.
SAJIDAN,, FATMAWATI, UMI, SURANTO,
core
Schematic representation of modes of microcrack nucleation, growth and temporary arrestment at different boundaries, with the criteria for crack propagation in three scenarios: (1) large notch, (2) defect/small sharp notch, and (3) long crack. This work revisits and integrates results on the fatigue behavior of advanced bainitic steels (in particular ...
Lucia Morales‐Rivas
wiley +1 more source
Removal of Hexavalent Chromium-Contaminated Wastewater by Micro-Emulsion Liquid Membrane Method
The micro-emulsion liquid membrane (MELM) was prepared for the extraction of hexavalent chromium (Cr (Ⅵ)) from wastewater. The membrane phase consists of kerosene as a membrane solvent, tributyl phosphate (TBP) as a mobile carrier, and sorbitan ...
Yan Li Yuan +3 more
core +1 more source
Sustainability assessment requires methodologies that appropriately distinguish between additive and non‐additive material properties. A toxicity‐weighted scoring system is developed and applied that accounts for the disproportionate influence of highly toxic constituents through nonlinear weighting functions, providing more realistic estimates than ...
Seth Mehalic +2 more
wiley +1 more source
采用硫酸盐还原菌处理含铬(Ⅵ)废水,研究了其去除铬(Ⅵ)的最适宜工艺条件。实验表明,该菌的适用范围广,处理含铬废水的能力强。在菌液与废液体积比为1.0:1、铬(Ⅵ)质量浓度为150mg/L条件下处理36h,铬(Ⅵ)去除率达99.9%
李福德 +3 more
core
HEA interlayers offer a versatile route for joining high‐performance structural materials. Their compositional and structural design regulates interfacial reactions, suppresses brittle IMCs, and improves metallurgical bonding. Sandwich interlayers further integrate defect healing with precipitation strengthening, enabling improved strength–ductility ...
Lin Yuan +4 more
wiley +1 more source
A Novel Approach to Estimate the Transition Temperature via Dynamic Nanoindentation
A new dynamic nanoindentation‐based method was developed that uses the stiffness ratio as an indicator of the elastic–plastic deformation contributions at different temperatures. The approach successfully identified transition temperatures in ferritic steel and distinguished them from continuously ductile austenitic steel.
Stefan Zeiler +4 more
wiley +1 more source
Additively manufactured AlCrFe2Ni2 with contrasting BCC/B2‐dominant and lamellar FCC + BCC/B2 microstructures exhibits the same pressure‐induced BCC/B2 → HCP transformation. Under laser heating at high pressure, HCP is destabilized, and a cubic BCC/B2 + FCC assemblage is recovered, while the lower‐scan‐speed microstructure transforms at a lower ...
Raimundas Sereika +5 more
wiley +1 more source
Impact of Hydrogen Incorporation on Electronic and Magnetic Structure of X2CrNi18‐9 Stainless Steel
Hydrogen uptake in austenitic stainless steel alters both its electronic and magnetic structure. Seebeck measurements reveal hydrogen‐induced shifts in the electronic density of states, while neutron scattering uncovers nanoscale inhomogeneities that grow upon hydrogen incorporation, with the most pronounced effect observed in the PBF as‐built state ...
Torben Tappe +9 more
wiley +1 more source
With the objective of exploring the mode of heavy metal chromium (Cr) accumulation in agricultural soils, the carbon quantum dot fluorescence method was established to analyze the CQDs-Cr (VI) system in the soil environment, and the relationship between ...
Yilei Chen, Ruiying Du, Lu Ni, Shuyu Liu
core +1 more source

