Results 11 to 20 of about 9,782,361 (275)
Fatigue crack growth rates under variable amplitude load spectra containing tensile underloads [PDF]
, 2003 An extensive research program was performed to investigate the load interaction effect of the combined action of small amplitude high R ratio cycles and large amplitude low R ratio underloads on the crack growth of large cracks.
Zitounis, Vasilios
core +7 more sources
Effect on Fatigue Performance of Residual Stress induced via Laser Shock Peening in Mechanically Damaged 2024‐T351 Aluminium Sheet [PDF]
, 2014 During manufacture and maintenance the fuselage skin of aircraft are susceptible to damage in the form of scratches. Normally not considered to be of major concern to aircraft structural integrity some airlines discovered fatigue cracks had initiated ...
Smyth, Niall
core +7 more sources
A study of fatigue crack propagation in quenched and tempered and controlled rolled HSLA steels. [PDF]
, 1987 A range of HSLA steels reflecting the two major processing routes, quench and tempering and controlled rolling, have been tested in fatigue to assess their potential wider application in the offshore Industry.
Callister, D. R.
core +7 more sources
Dual boundary element method for axisymmetric crack analysis [PDF]
, 2002 In this paper a dual boundary element formulation is developed and applied to the evaluation of stress intensity factors in, and propagation of, axisymmetric cracks.
Wrobel, LC, Lacerda, LA
core +6 more sources
Materials & Design, 2023 Clarifying residual stress (RS) redistribution and its effect on fatigue crack growth (FCG) is essential to evaluate the fatigue life of a welded joint.
Shuai Luan, Chunguo Zhang, Xing Zhang
doaj +1 more source
Fatigue Crack Growth from Notches: A Numerical Analysis
Applied Sciences, 2020 A numerical approach based on plastic crack tip opening displacement (CTOD) was followed to study fatigue crack growth (FCG) from notches. The identification of fundamental mechanisms was made considering notched and unnotched models, with and without ...
Micael Borges +4 more
doaj +1 more source
Frontiers in Earth Science, 2023 The crack closure in impact coal seams induced by high-pressure air blasting greatly affects gas drainage efficiency. The length of the crack closure was calculated and analyzed based on energy and elastic theories. The closure region was then determined
Weihua Song +3 more
doaj +1 more source
Crack closure effect of fatigue crack under cyclic tensile loading
Nihon Kikai Gakkai ronbunshu, 2015 The objective of this study is to evaluate crack growth behavior under cyclic tensile loading considering crack closure effect. Crack growth behavior under cyclic tensile loading on a plate with surface crack is tested.
Akiyuki TAKAHASHI +3 more
doaj +1 more source
Assessment of 3D Short Crack Closure in Ti-6Al-4V Alloy Utilizing Synchrotron X-ray Microtomography [PDF]
MATEC Web of Conferences, 2020 Synchrotron X-ray microtomography was utilized to observe the complex 3D crack morphology and the closure behavior of a short crack in Ti-6Al-4V alloy. The aim of the study was to investigate the effect of the crack path evolution on the 3D short crack ...
TUBEI Valary +5 more
doaj +1 more source
Three-Dimensional Surface Crack Growth of Maraging Steel Spherical Pressure Shell
Journal of Marine Science and Engineering, 2021 This study focused on the three-dimensional surface crack growth of a spherical pressure shell. Eight maraging steel 18Ni (250) samples were fabricated and tested, and the fatigue crack growth rate curves were obtained.
Yongmei Zhu, Rujun Li, Jiahao Yang
doaj +1 more source