Determination of fracture mechanics parameters on a base of local displacement measurements [PDF]
Fracture and Structural Integrity, 2013 New experimental technique for a determination of the stress intensity factor (SIF) and T-stress values is developed and verified. The approach assumes combining the crack compliance method and optical interferometric measurements of local deformation ...
Yu. G. Matvienko +2 more
doaj +3 more sources
Meitan xuebao, 2023 In order to study the fatigue behavior of porous weakly cemented siltstone, a quantitative calculation method of characteristic stress was established based on uniaxial step loading and unloading tests of siltstone.
Mingchun LIANG +4 more
doaj +1 more source
Damage accumulation near the cold-expanded hole due to high-cycle fatigue by crack compliance method
Fracture and Structural Integrity, 2022 The novel destructive method is implemented for quantitative assessment of fatigue damage accumulation in the stress concentration zone accompanied by residual stress due to cold expansion of the through-thickness hole.
Yu. G. Matvienko +3 more
doaj +1 more source
Crack propagation under variable amplitude loading [PDF]
Materials Research, 2013 Experience shows that a damage induced by a given cycle is dependent on the loading history. In this regard, the objective of this paper is to study and describe the phenomenology of the loading history on crack propagation.
Miloudi Abdelkader +4 more
doaj +1 more source
Determining mode I cohesive law of Pinus pinaster by coupling double cantilever beam test with digital image correlation [PDF]
Fracture and Structural Integrity, 2015 The direct identification of the cohesive law in pure mode I of Pinus pinaster is addressed. The approach couples the double cantilever beam (DCB) test with digital image correlation (DIC).
J. Xavier +3 more
doaj +1 more source
The effect of low-cycle fatigue on evolution of fracture mechanics parameters in residual stress field caused by cold hole expansion [PDF]
Fracture and Structural Integrity, 2019 Localized displacement measurements based on electronic speckle-pattern interferometry are used to obtain crack mouth opening displacement (CMOD), stress intensity factor (SIF) and T-stress values during crack growth around cold-expanded holes.
Yu. G. Matvienko +2 more
doaj +1 more source
Residual Stress Prediction in Multi-layer Butt Weld Using Crack Compliance Method [PDF]
Journal of the Korean Welding and Joining Society, 2012 Abstract It depends on the joint configuration, dimensions and constraints of the joint whether the residual stress at the root of single-sided butt weld is tensile or not. Therefore, recommendation is generally made that highR ratio should be used in the fatigue test of welded joint in order to prevent excessively long life caused by compressive ...
Yooil Kim, Jang Hyun Lee
openaire +1 more source
Characteristics of the double-torsion test to determine the R-curve of ceramic materials
Materials Research, 2006 Double-torsion tests were carried out on a commercial ceramic floor tile to verify whether this test is suitable for determining the R-curve of ceramics.
Maria da Consolação Fonseca de Albuquerque +1 more
doaj +1 more source
Lengthwise Fracture Study of Transversely Inhomogeneous Rods
Engineering Transactions, 2020 A lengthwise crack in a rod that exhibits smooth (continuous) material inhomogeneity in the transverse direction is studied. The rod has a circular cross-section. The lengthwise crack is located arbitrarily along the thickness of the rod.
Victor Iliev RIZOV
doaj +1 more source
The compliance approach for analyzing biomaterial interface cracks
Computer Assisted Methods in Engineering and Science, 2023 A numerical method is presented for analyzing the mixed mode interface crack between two dissimilar isotropic materials. A simple and efficient solution procedure is developed based on the finite element method and the compliance approach in conjunction
Hisham Abdel-Fattah, Sameer A. Hamoush
doaj