Results 221 to 230 of about 1,306,615 (288)

Subsurface Fracture Mapping in Adhesive Interfaces Using Terahertz Spectroscopy. [PDF]

Materials (Basel)
Singh M, Karmarkar S, Herbsommer M, Yoon S, Tomar V.   +4 more
europepmc   +1 more source

Tensile Response and Energy Absorption of Galvanized Steel Mesh-Reinforced Cement Mortar with Alkali-Resistant Glass Fibers. [PDF]

Materials (Basel)
Rodríguez L, Valle R, Garrido C, Valenzuela M, Tuninetti V, Núñez F.   +5 more
europepmc   +1 more source

Failure analysis of coal-rock composites with different coal thicknesses under uniaxial loading based on resistivity response and damage evolution. [PDF]

Sci Rep
Tian C, Liu J, Liu J, Liu W, Wang W, Liu B, Sun Y.   +6 more
europepmc   +1 more source

Hierarchical Fractal Interfaces in 3D-Printed Stiff-Soft Polymer Composites: Fracture Resistance and Toughening Mechanisms. [PDF]

Polymers (Basel)
Lin PR, Tsai YC, Chen PY.
europepmc   +1 more source

Increasing both strength and toughness in ceramic-matrix composites via bioinspired porous interphases. [PDF]

Nat Commun
Hong W, Pang X, Yan H, Zhang Z, Li L, Zhang Z, Fang D.   +6 more
europepmc   +1 more source

Advanced energy-based and two-degree-of-freedom analytical modeling of reinforced concrete slabs subjected to low-velocity impact and equivalent blast loading. [PDF]

Sci Rep
Al-Dala'ien RN, Al-Ezzi MJ, Syamsir A.
europepmc   +1 more source

Microscopic measurement of the local deformation field establishes the mechanistic origin of the fatigue threshold for soft brittle materials.

Soft Matter
Altuntas U, Li C, Kolinski JM.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

A new method of crack-tip opening displacement determined based on maximum crack opening displacement

Engineering Fracture Mechanics, 2011
Abstract In this paper a new method is presented to determine the crack-tip opening displacement (CTOD) for the center cracked plate with uniaxial uniform tension load. The maximum crack opening displacement (MCOD) is adopted to estimate CTOD. Based on the series of calculation results by elastic–plastic finite element simulation, an explicit ...
Yi Huang
exaly   +2 more sources

Overstraining effects on the crack-opening displacement of microstructurally short cracks

Materials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing, 2005
The influence of different overstraining events on the crack-opening displacement of microstructurally short cracks in polycrystalline nickel was investigated. Both symmetric and asymmetric overstraining experiments were carried out and the influence of increasing overstraining ratio and number of overstraining cycles was analysed.
Anja Weidner, C Blochwitz, W Tirschler
exaly   +2 more sources

Crack opening displacement and propagation rate of microstructurally short cracks

Materials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing, 2003
Crack opening displacement (COD) along the edges of microstructurally short fatigue cracks in austenitic stainless steel was investigated in situ in the SEM. The measured plastic part of the COD range between maximum and minimum load was extrapolated to the near crack tip region, assuming plastic blunting and resharpening by cooperative slip as well ...
Anja Weidner, C Blochwitz, W Tirschler
exaly   +2 more sources