Results 31 to 40 of about 93,821 (280)
Problems and Key Factors of CRM Implementation
Communications, 2009 CRM value chain identifies five key steps in the development and implementation of a CRM strategy: customer portfolio analysis, customer intimacy, network development, value proposition development, and manage customer life cycle.
Viliam Lendel
doaj +1 more source
Advanced Materials, EarlyView.Cancer‐associated NPC remodeling creates a high‐flux, low‐stringency nuclear state that supports malignant adaptation but increases mechanical fragility. Targeting the FG‐barrier or NPC scaffold may drive mechanostat failure, envelope rupture, DNA damage, and loss of nuclear integrity.
Sílvio Terra Stefanello +5 more
wiley +1 more source
Rapid, systematic updating of movement by accumulated decision evidence
Nature CommunicationsActing in the natural world requires not only deciding among multiple options but also converting decisions into motor commands. How the dynamics of decision formation influence the fine kinematics of response movement remains, however, poorly understood.
Manuel Molano-Mazón +7 more
doaj +1 more source
Artificial Intelligence Meets Micro/Nanorobotics
Advanced Materials, EarlyView.Artificial intelligence is transforming micro‐ and nanorobots from externally controlled, task‐specific machines into adaptive, autonomous systems. Machine learning, multimodal perception, digital twins, AI‐guided materials and geometry design enhance propulsion, localization, decision‐making, whichaccelerates clinical and environmental applications ...
Fatma M. Yurtsever +6 more
wiley +1 more source
Advanced Materials, EarlyView.A novel selective laser sintering and graphitization (SLSG) 3D printing technology enables unibody fabrication of compacted insulating structures and conductive circuits in fluidic‐integrated wearable electronics through adaptive photonic modulation.
Li Zhang, Wing Cheung Mak
wiley +1 more source
Journal of Mechanical EngineeringA numerical study using ANSYS Fluent 18.1 software was conducted to examine the fluid flow and heat transfer characteristics in a cross-flow heat exchanger equipped with rectangular, hexagonal, and semi-elliptical finned tubes. Simulations were performed
Bouhabel Bourhane +5 more
doaj +1 more source
FEATURES IN THE DEVELOPMENT OF INFORMATION SYSTEMS TO SMALL BUSINESSES
Российский технологический журнал, 2016 The development of information systems for small enterprises despite the objective difficulties and reduced budgets for IT infrastructure requires an in-depth strategic approach.
K. Shishmanov
doaj +1 more source
The Randomized CRM: An Approach to Overcoming the Long-Memory Property of the CRM [PDF]
Journal of Biopharmaceutical Statistics, 2017 The primary object of a phase I clinical trial is to determine the maximum tolerated dose (MTD). Typically, the MTD is identified using a dose-escalation study, where initial subjects are treated at the lowest dose level and subsequent subjects are treated at progressively higher dose levels until the MTD is identified.
Koopmeiners, Joseph S., Wey, Andrew
openaire +3 more sources
Sustainable Materials Design With Multi‐Modal Artificial Intelligence
Advanced Science, EarlyView.Critical mineral scarcity, high embodied carbon, and persistent pollution from materials processing intensify the need for sustainable materials design. This review frames the problem as multi‐objective optimization under heterogeneous, high‐dimensional evidence and highlights multi‐modal AI as an enabling pathway.
Tianyi Xu +8 more
wiley +1 more source
Integrated Environmental Assessment and Management, EarlyView., 2023 Abstract In the Lake Koocanusa‐Kootenai River system (Montana, USA and British Columbia, Canada), selenium (Se) contamination has become an international concern and is suspected to contribute to the observed burbot (Lota lota) population collapse. Due to our limited ability to sample burbot in Lake Koocanusa for monitoring studies, we used a reference
Stephanie D. Graves +6 more
wiley +1 more source