Results 81 to 90 of about 563,433 (299)
Elastic response of zone axis (001)-oriented PWA 1480 single crystal: The influence of secondary orientation [PDF]
The influence of secondary orientation on the elastic response of a zone axis (001)-oriented nickel-base single-crystal superalloy, PWA 1480, was investigated under mechanical loading conditions by applying finite element techniques.
Abdul-Aziz, Ali +2 more
core +1 more source
Observation of metastable hcp solid helium
, 2011 We have produced and observed metastable solid helium-4 below its melting pressure between 1.1 K and 1.4 K. This is achieved by an intense pressure wave carefully focused inside a crystal of known orientation. An accurate density map of the focal zone is
Andreev A. F. +6 more
core +2 more sources
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
MicromachinesCrystal orientation significantly influences deformation during nanopolishing due to crystal anisotropy. In this work, molecular dynamics (MD) simulations were employed to examine the process of surface generation and subsurface damage.
Bo Zhao +4 more
doaj +1 more source
Anisotropic backscatter in ice-penetrating radar data: potential mechanisms and implications [PDF]
, 2010 Airborne and ground-based radar have been used extensively in the past to measure ice thickness and to investigate the internal structure of ice sheets in terms of layering.
Drews, Reinhard +4 more
core
Advanced Engineering Materials, EarlyView.This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani +2 more
wiley +1 more source
SSME single-crystal turbine blade dynamics [PDF]
A study was performrd to determine the dynamic characteristics of the Space Shuttle Main Engine high pressure fuel turbopump (HPFTP) blades made of single crystal (SC) material. The first and second stage drive turbine blades of HPFTP were examined.
Moss, Larry A.
core +1 more source
Anisotropic shear melting and recrystallization of a two-dimensional complex (dusty) plasma
, 2013 A two-dimensional plasma crystal was melted by suddenly applying localized shear stress. A stripe of particles in the crystal was pushed by the radiation pressure force of a laser beam.
Ivlev, A. V. +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
A uniqueness and regularity criterion for Q-tensor models with Neumann boundary conditions [PDF]
, 2014 We give a regularity criterion for a $Q$-tensor system modeling a nematic Liquid Crystal, under homogeneous Neumann boundary conditions for the tensor $Q$.
Guillén-González, Francisco +1 more
core +1 more source