Results 21 to 30 of about 2,304,730 (298)
On the Measurement of Ocean Near-Surface Current from a Moving Buoy
Journal of Marine Science and Engineering, 2023 This paper studies the error that occurs when measuring surface currents with a current meter mounted on a buoy or a mooring line whose horizontal and vertical motions respond to the presence of waves.
Carlos F. Herrera-Vázquez +4 more
doaj +1 more source
Effective control of the error in a direct measurement of core-loss power [PDF]
, 1995 Accuracy of a direct measurement of core-loss power is severely limited in many applications by the extra phase shift between the measured voltage and current.
Tan, F. Dong +2 more
core +1 more source
Приборы и методы измерений, 2017 In carrying out eddy current thickness measurement of two-layer conductive objects one from the interfering factors is the presence of variations in the value of the electrical conductivity of the material of the upper layer (coating) when moving from ...
A. V. Chernyshev
doaj +1 more source
Current and voltage based bit errors and their combined mitigation for the Kirchhoff-law-Johnson-noise secure key exchange [PDF]
, 2013 We classify and analyze bit errors in the current measurement mode of the Kirchhoff-law-Johnson-noise (KLJN) key distribution. The error probability decays exponentially with increasing bit exchange period and fixed bandwidth, which is similar to the ...
Gingl, Zoltan +4 more
core +2 more sources
Intrabeam Scattering Analysis of ATF Beam Measurements [PDF]
, 2001 At the Accelerator Test Facility (ATF) at KEK intrabeam scattering (IBS) is a strong effect for an electron machine. It is an effect that couples all dimensions of the beam, and in April 2000, over a short period of time, all dimensions were measured as ...
Bane, K. L. F. +5 more
core +2 more sources
TMR array with circular skeleton coil for high-current measurement
Energy Reports, 2021 DC high current measurement is one of the important supporting technologies of the power system. As an emerging current sensing technology, tunnel magnetoresistance (TMR) has attracted more and more attention due to its advantages of high sensitivity and
Changxi Yue +4 more
doaj +1 more source
Zero‐Sequence current measurement uncertainty in three‐phase power systems during normal operation
IET Generation, Transmission & Distribution, 2021 Zero‐sequence currents in high‐voltage power systems during normal operation can have a significant influence on nearby infrastructure. It is therefore necessary to gain insight into typical levels of zero‐sequence currents in a variety of operational ...
Sjoerd Nauta, Ramiro Serra
doaj +1 more source
Protection Loop Error Measurement Based on Factor Analysis and Statistics Technology
Zhongguo dianli, 2023 In order to improve the reliability of the protection measurement circuit and ensure the safe operation of the power system, which requires the measurement error of the protection device to be solved in time.
Yawen YI +5 more
doaj +1 more source
Errors in measurement of current distribution in a superconducting tape [PDF]
Superconductor Science and Technology, 2011 The paper reports on the role of the typical mapping errors in measurement of the lateral sheet current distribution Iy(x) in a superconducting tape. The sheet current is calculated indirectly, from the mapped data of the self magnetic field of the superconducting layer. The field is generated by transport or induced current in a tape.
openaire +1 more source
Analysis and Compensation of Current Measurement Errors in Machine Drive Systems—A Review
EnergiesThe rapid development of machine drive systems is closely tied to advancements in signal sampling technology. Accurate measurement results, especially current measurement results, are crucial for high-performance machine drive systems.
Pingyue Song +5 more
doaj +1 more source