Results 51 to 60 of about 332,580 (160)
This paper proposes a new scheme of reconstructing current sensor faults and estimating unknown load disturbance for a permanent magnet synchronous motor (PMSM)-driven system.
Kaihui Zhao +5 more
doaj +1 more source
Online Calibration Method for Current Sensors Based on GPS
At present, most sensor calibration methods are off-line calibration, which not only makes them time-consuming and laborious, but also causes considerable economic losses.
Shuang Zhao, Jun Liu, Yansong Li
doaj +1 more source
Development of a Magnetostrictive FeNi Coated Surface Acoustic Wave Current Sensor
A magnetostrictive FeNi-coated surface acoustic wave (SAW)-based current sensor was proposed in this work. The weak remanence and hysteresis effect of the FeNi itself contributes to suppress the asymmetry in sensor response at increasing and decreasing ...
Jie Tong +6 more
doaj +1 more source
Hall Element Used in the Current Sensor
This paper took the Hall effect as a starting point to expound relationship of the Hall element structure, the driving circuit, the technical parameters, the pins and Hall iron core.
米哲涛, 曹雷
doaj
PCB-Embedded Spiral Pattern Pick-Up Coil Current Sensor for WBG Devices
This paper proposes a current sensor for wide bandgap (WBG) devices. The current of a power semiconductor device is mainly measured using a Rogowski coil, an active current transformer, and a coaxial shunt resistor.
Hwa-Rang Cha +3 more
doaj +1 more source
Direct-drive wind turbines take a large share of wind power markets, in particular offshore wind power because of its simple structure, so that its fault diagnosis caused by adverse circumstances become research highlights.
LI Zhiyong +3 more
doaj
Fiber‐Integrated Diamond Quantum Sensor for High‐Voltage Current Measurements
In power network systems, there is an urgent demand for highly accurate and miniaturized sensors, owing to their high safety level and limited installation space.
Qihui Liu +13 more
doaj +1 more source
Magnetoelectric Sensor Operating in d15 Thickness-Shear Mode for High-Frequency Current Detection
For the application of high-frequency current detection in power systems, such as very fast transient current, lightning current, partial discharge pulse current, etc., current sensors with a quick response are indispensable.
Fuchao Li +13 more
doaj +1 more source
Current Sensor Fault Diagnosis Based on a Sliding Mode Observer for PMSM Driven Systems
This paper proposes a current sensor fault detection method based on a sliding mode observer for the torque closed-loop control system of interior permanent magnet synchronous motors.
Gang Huang +4 more
doaj +1 more source
A New Mirroring Circuit for Power MOS Current Sensing Highly Immune to EMI
This paper deals with the monitoring of power transistor current subjected to radio-frequency interference. In particular, a new current sensor with no connection to the power transistor drain and with improved performance with respect to the existing ...
Orazio Aiello, Franco Fiori
doaj +1 more source

