Numerical Modeling of the Effect of Cutting-Edge Radius on Cutting Force and Stress Concentration during Machining [PDF]
Micromachines, 2022 Cutting is the primary method of material removal, and the quality of machined parts depends on the geometry of cutting tools. In this paper, a new cutting force coefficient model is established, revealing the influence of cutting-edge radius on the ...
Peng Li, Zhiyong Chang
doaj +2 more sources
High-Precision Cutting Edge Radius Measurement of Single Point Diamond Tools Using an Atomic Force Microscope and a Reverse Cutting Edge Artifact [PDF]
Applied Sciences, 2020 This paper presents a measurement method for high-precision cutting edge radius of single point diamond tools using an atomic force microscope (AFM) and a reverse cutting edge artifact based on the edge reversal method.
Kai Zhang +4 more
doaj +2 more sources
Influence of cutting edge radius on surface integrity and burr formation in milling titanium [PDF]
The International Journal of Advanced Manufacturing Technology, 2012 ISSN:1433 ...
Wyen, Carl-Frederik +2 more
openaire +5 more sources
Determination of the Minimum Uncut Chip Thickness of Ti-6Al-4V Titanium Alloy Based on Dead Metal Zone [PDF]
MicromachinesIn Ti-6Al-4V titanium alloy micro-machining, since the uncut chip thickness (UCT) is comparable to the radius of the tool cutting edge, there exists a minimum uncut chip thickness (MUCT), and when the UCT is smaller than the MUCT, the plowing effect ...
Yaohui Zheng +4 more
doaj +2 more sources
Investigation on the size effect in micro end milling considering the cutting edge radius and the workpiece material [PDF]
Mechanical Sciences, 2021 Previous research has found that the peripheral and end cutting edges of the cutter had different cutting mechanisms in the micro end cutting process considering the size effect. This investigation is a further study on this point considering the cutting
Y. Li, X. Cheng, G. Zheng, H. Liu
doaj +1 more source
Influence of the radius of the generatrix of flank surface on the geometric parameters of the cutting wedge of the twist drill [PDF]
E3S Web of Conferences, 2023 Drills with various flank surface shapes are widely used to machine holes. Drill teeth have flank surfaces of various shapes, flat, conical and helical.
Pivkin Petr +3 more
doaj +1 more source
Micromachines, 2022 Reasonable cutting edge preparation can eliminate microscopic defects and improve the performance of a cutting tool. The flexible fiber-assisted shear thickening polishing method was used for the preparation of cemented carbide insert cutting edge.
Lanying Shao +6 more
doaj +1 more source
Lubricants, 2023 To improve the cutting performance of the core drill, the flexible fiber assisted shear-thickening polishing (FF-STP) for cutting edge preparation was proposed to eliminate the microscopic defect and obtain proper radius of the cutting edge of the core ...
Lanying Shao +3 more
doaj +1 more source
Research on grinding quality and removal mechanism of polycrystalline diamond tools
Jin'gangshi yu moliao moju gongcheng, 2022 Aiming at grinding quality of polycrystalline diamond (PCD) tools, the grinding experiment was carried out to optimize the process parameters with cutting edge radius, cutting edge defect and flank roughness as the indexes. The grinding removal mechanism
Sen WANG +4 more
doaj +1 more source
Journal of Manufacturing and Materials Processing, 2022 Punching of ultra-high-strength spring steel causes critical stresses in the tools. Pronounced wear and even spontaneous failure may occur. Wear of the punches influences the quality of the cutting surfaces of the blanked parts, which is predominantly ...
Sven Winter +5 more
doaj +1 more source