Results 101 to 110 of about 804,929 (308)
Research on Cutting Load and Heat Generation Law of PDC Wearing Cutter
Shiyou jixie, 2021 At present, there is no further researches on the cutting load and heat generation of worn PDC cutter under different front rake angles and different wear grades. For this reason, single cutter cutting tests are used to verify the relevant performance of
Zhu Guanghui, Kuang Yuchun, Lin Wei
doaj
Submerged cutting characteristics of abrasive suspension jet
Nihon Kikai Gakkai ronbunshu, 2015 An abrasive suspension jet (ASJ) formed by propelling abrasive suspension through a nozzle has a greater cutting capability than the conventional abrasive water jet.
Seiji SHIMIZU +3 more
doaj +1 more source
Experimental Study on the Grinding of an Fe-Cr-Co Permanent Magnet Alloy under a Small Cutting Depth. [PDF]
Micromachines (Basel), 2022 Wang N +6 more
europepmc +1 more source
Surface quality and chip formation in turning of LM6 aluminium alloy and particulate reinforced metal matrix composite [PDF]
, 2014 Majority of the components of aerospace and automotive vehicles need different machining operations, mainly for the assembly requirements. The components have to present both high dimensional precision and surface quality.
Ismail, Napsiah +3 more
core +1 more source
On Minimum Depth of Cut in nanomachining [PDF]
, 2010 The concept of Minimum Depth of Cut (MDC) is that the depth of cut must be over a certain critical thickness before any chip is formed. It is actually a major limiting factor on achievable accuracy in nanomachining, because the generated surface roughness is primarily attributed to the ploughing process when the uncut chip thickness is less than the ...
Oluwajobi, Akinjide O., Chen, Xun
openaire
Effect of Oxygen Content on Surface and Subsurface Integrity During Turning of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.This study examines how oxygen content in the ambient atmosphere affects the surface and subsurface properties of Ti–6Al–4V during turning. Results show that oxygen does not influence surface roughness. However, machining in an extremely high vacuum‐adequate atmosphere increases surface hardness by up to 7.8% and induces compressive residual stresses ...
Benjamin Bergmann +3 more
wiley +1 more source
Applied SciencesThe differential distribution of original rock stress and stress concentration caused by the variation in coal seam depth in karst topography are critical factors influencing the selection of roof-cutting parameters.
Yutao Liu +6 more
doaj +1 more source
Effect of cutting depth during sugarcane (Saccharum spp. hybrid) harvest on root characteristics and yield. [PDF]
PLoS One, 2021 Yang SL +7 more
europepmc +1 more source
Towards understanding the cutting and fracture mechanism in ceramic matrix composites [PDF]
, 2017 Ceramic Matrix Composites (CMCs) are increasingly used for the manufacture of high-value parts for several industries such as the aerospace, nuclear and automotive.
Axinte, Dragos A., Gavaldà Díaz, O.
core +2 more sources
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source