Results 241 to 250 of about 401,853 (305)
Machining performance investigation on 17-4PH steel material with innovative textured tools. [PDF]
Sci RepSivaiah P +5 more
europepmc +1 more source
Effective Thoracic Duct Ligation at T9 for Postoperative Chylothorax: A Case Report. [PDF]
CureusNabe Y, Mizuuchi H, Inoue M, Yoshida J.
europepmc +1 more source
CBN cutting tool's surface roughness and tool wear prediction using JOA-optimized CNN-LSTM. [PDF]
Sci RepKhetre S, Bongale A, Kumar S.
europepmc +1 more source
Sustainable machining of heat resistant superalloys using hybrid nanofluid based minimum quantity lubrication. [PDF]
Sci RepChohan JS +7 more
europepmc +1 more source
Circulating purification of cutting fluid: an overview [PDF]
International Journal of Advanced Manufacturing Technology, 2021 Changhe Li, Zafar Said, Sujan Debnath
exaly +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Contact Dermatitis, 1989
174 consecutive patients with suspected cutting fluid dermatitis were investigated in 2 occupational dermatology clinics. 43% showed allergic reactions which were thought to be relevant to their dermatitis. Irritant contact dermatitis occurred in 63%, but only in 21% was it thought to be the sole diagnosis.
C E, Grattan +3 more
openaire +2 more sources
174 consecutive patients with suspected cutting fluid dermatitis were investigated in 2 occupational dermatology clinics. 43% showed allergic reactions which were thought to be relevant to their dermatitis. Irritant contact dermatitis occurred in 63%, but only in 21% was it thought to be the sole diagnosis.
C E, Grattan +3 more
openaire +2 more sources
Control of cutting fluid in metal cutting and dry cutting
2011 International Conference on Remote Sensing, Environment and Transportation Engineering, 2011A lot of cutting fluid in metal cutting process causes environmental pollution and increases the manufacturing cost. Control of cutting fluid is one of the serious problems that the modern manufacturing technology faces with. This paper describes in brief the development tendency of cutting fluid and its limitations.
null Jianzhong Zhang +2 more
openaire +1 more source
Industrial Lubrication and Tribology, 1974
These authors reported work on cutting oils in our September/October 1972 issue and this paper describes a continuation of their work. The selection of special cutting fluids and lubricants can significantly affect metal cutting operations. Friction forces during metal cutting can increase the amount of work to be done to deform the material, can ...
H. Bagchi, S.K. Basu
openaire +1 more source
These authors reported work on cutting oils in our September/October 1972 issue and this paper describes a continuation of their work. The selection of special cutting fluids and lubricants can significantly affect metal cutting operations. Friction forces during metal cutting can increase the amount of work to be done to deform the material, can ...
H. Bagchi, S.K. Basu
openaire +1 more source
Industrial Lubrication and Tribology, 1987
SYNOPSIS. A new type of cutting fluid is essential to achieving utilisation of the full potential of Automated Machining (AM). Coolant capabilities frequently determine the scope of multi‐tool machining applications. Identifying operational needs and overcoming AM system constraints has provided a unique opportunity to develop a new synthetic cutting ...
openaire +1 more source
SYNOPSIS. A new type of cutting fluid is essential to achieving utilisation of the full potential of Automated Machining (AM). Coolant capabilities frequently determine the scope of multi‐tool machining applications. Identifying operational needs and overcoming AM system constraints has provided a unique opportunity to develop a new synthetic cutting ...
openaire +1 more source