Results 231 to 240 of about 3,826,227 (356)
Bit Wear and Cutting Force in Rock Cutting
Shigen-to-Sozai, 1999 Seisuke OKUBO +3 more
openaire +2 more sources
Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions
Advanced Engineering Materials, EarlyView.This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel +6 more
wiley +1 more source
Two-Dimensional Finite Element Analysis and Cutting Force Model for the Cutting of Circular Steel Bars Using Negative Rake Angle Cutters: Accounting for Chip Accumulation Effects. [PDF]
Materials (Basel)Qiao S, Feng C, Wang G, Liu T, Singh J.
europepmc +1 more source
Cutting forces in unconstrained machining [PDF]
Mechanik, 2016 Borys Storch, Anna Zawada-Tomkiewicz
openaire +1 more source
Advanced Engineering Materials, EarlyView.The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
Energy efficiency identification and surface roughness prediction using cutting force signal for computer numerical controlled machine systems. [PDF]
Sci RepFeng C, Li M, Guo H, Qiu B, Zhang J.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin +5 more
wiley +1 more source
Tool Run-Out in Micro-Milling: Development of an Analytical Model Based on Cutting Force Signal Analysis. [PDF]
Micromachines (Basel)Abeni A +4 more
europepmc +1 more source
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates how optimizing laser power, scanning speed, and hatching distance in laser powder bed fusion can boost the productivity of Inconel 718 manufacturing by up to 29% while maintaining mechanical integrity. The work delivers a validated process window and cost–time analysis, offering industry‐ready guidelines for efficient additive ...
Amir Behjat +7 more
wiley +1 more source