Results 1 to 10 of about 666,453 (214)
Cutting Forces Simulation for End Milling
Журнал інженерних наук, 2023 The cutting force in end milling is the essential perturbation of the machining system that limits the productivity of the process. Therefore, forecasting the cutting force when assigning the processing mode and the geometry of the allowance layer to be ...
Petrakov Y. V. +3 more
doaj +3 more sources
An error compensation controller for milling robots
Vietnam Journal of Mechanics, 2023 This paper presents a method of controlling a serial robot for milling by an inverse kinematic controller combined with an outer PD loop (Inverse Dynamics + PD controller), with calibration and compensation of errors in calculating the cutting forces ...
Phan Bui Khoi +2 more
doaj +1 more source
International Journal for Simulation and Multidisciplinary Design Optimization, 2021 Micromilling is one of the preferable micro-manufacturing process, as it exhibits the flexibility to produce complex 3D micro-parts. The cutting forces generated in micro end milling can be attributed for tool vibration and process instability.
Bhople Narendra +2 more
doaj +1 more source
Monitoring of the Average Cutting Forces from Controller Signals using Artificial Neural Networks
Journal of Machine Engineering, 2022 A new approach is presented to monitor the average cutting forces that are used for the calculation of the average cutting coefficients through neural networks using available controller signals. The cutting forces and the relevant controller signals are
Nevzat Bircan Bugdayci +2 more
doaj +1 more source
Identification and analysis of cutting force coefficients in the helical milling process
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2020 Cutting forces are often used to optimize cutting parameters and analyze cutting characteristics of the tool. Accurate prediction of cutting forces is critical to understand deeply of the cutting process, especially for helical milling of the difficult ...
Haiyan WANG +4 more
doaj +1 more source
An Innovative Experimental Study of Corner Radius Effect on Cutting Forces [PDF]
, 2014 The cutting forces are often modelled using edge discretisation methodology. In finish turning, due to the smaller corner radii, the use of a local cutting force model identified from orthogonal cutting tests poses a significant challenge. In this paper,
BISSEY BRETON, Stéphanie +3 more
core +6 more sources
Experimental investigation of cutting forces in high-feed milling of titanium alloy [PDF]
, 2020 Titanium super alloys are often used in the chemical and aerospace industries, especially because of financial savings. resulting primarily from cheaper operation of equipment. Machinability of titanium alloys is more difficult than that of other metals.
Drábek, Lukáš +5 more
core +1 more source
An investigation on the mechanics of nanometric cutting and the development of its test-bed [PDF]
, 2003 The mechanics of machining at a very small depth of cut (100 nm or less) is not well understood. The chip formation physics, cutting forces generation, resulting temperatures and the size effects significantly affect the efficiency of the process and ...
Cheng, K, Guo, XJ, Holt, R, Luo, X
core +2 more sources
Advances in Mechanical Engineering, 2020 Micro-textured cutting tools were widely reported due to the improved cutting performance, for example, the reduction of cutting forces. However, the cutting performance is significantly dependent on the parameters of the micro-textures.
Haidong Yang +8 more
doaj +1 more source
RUDN Journal of Engineering Research, 2023 The requirements for the quality and accuracy of manufactured products are constantly increasing. Reliability, durability, and accuracy of machine operation largely depend on the quality of surface treatment.
Kazem Reza Kashyzadeh +2 more
doaj +1 more source