Results 11 to 20 of about 53,986 (258)
Cutting Forces Simulation for End Milling
Журнал інженерних наук, 2023 The cutting force in end milling is the essential perturbation of the machining system that limits the productivity of the process. Therefore, forecasting the cutting force when assigning the processing mode and the geometry of the allowance layer to be ...
Petrakov Y. V. +3 more
doaj +1 more source
An error compensation controller for milling robots
Vietnam Journal of Mechanics, 2023 This paper presents a method of controlling a serial robot for milling by an inverse kinematic controller combined with an outer PD loop (Inverse Dynamics + PD controller), with calibration and compensation of errors in calculating the cutting forces ...
Phan Bui Khoi +2 more
doaj +1 more source
International Journal for Simulation and Multidisciplinary Design Optimization, 2021 Micromilling is one of the preferable micro-manufacturing process, as it exhibits the flexibility to produce complex 3D micro-parts. The cutting forces generated in micro end milling can be attributed for tool vibration and process instability.
Bhople Narendra +2 more
doaj +1 more source
Modeling the Forces of Cutting With Scissors [PDF]
IEEE Transactions on Biomedical Engineering, 2008 Modeling forces applied to scissors during cutting of biological materials is useful for surgical simulation. Previous approaches to haptic display of scissor cutting are based on recording and replaying measured data. This paper presents an analytical model based on the concepts of contact mechanics and fracture mechanics to calculate forces applied ...
Mohsen Mahvash +5 more
openaire +2 more sources
Monitoring of the Average Cutting Forces from Controller Signals using Artificial Neural Networks
Journal of Machine Engineering, 2022 A new approach is presented to monitor the average cutting forces that are used for the calculation of the average cutting coefficients through neural networks using available controller signals. The cutting forces and the relevant controller signals are
Nevzat Bircan Bugdayci +2 more
doaj +1 more source
Identification and analysis of cutting force coefficients in the helical milling process
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2020 Cutting forces are often used to optimize cutting parameters and analyze cutting characteristics of the tool. Accurate prediction of cutting forces is critical to understand deeply of the cutting process, especially for helical milling of the difficult ...
Haiyan WANG +4 more
doaj +1 more source
Prediction of sand mold cutting force and identification of cutting force coefficients
Journal of Physics: Conference Series, 2021 Abstract Patternless casting technology is an advanced digital forming technology. Sand mold cutting is one of the most important techniques of patternless casting technology. In the process of sand mold cutting, the cutting force is the key factor affecting the quality of sand mold machining, and is an important prerequisite for the ...
Hou Ming-Peng +3 more
openaire +1 more source
Advances in Mechanical Engineering, 2020 Micro-textured cutting tools were widely reported due to the improved cutting performance, for example, the reduction of cutting forces. However, the cutting performance is significantly dependent on the parameters of the micro-textures.
Haidong Yang +8 more
doaj +1 more source
Vibration assisted cutting of Gouda cheese
Czech Journal of Food Sciences, 2012 The influence of vibrations on the process of cheese cutting applied in order to reduce friction and the cutting force was studied. The forces needed to cut through the cheese samples were measured against the variations of the temperature, cutting speed,
Andrej Lebar +3 more
doaj +1 more source
RUDN Journal of Engineering Research, 2023 The requirements for the quality and accuracy of manufactured products are constantly increasing. Reliability, durability, and accuracy of machine operation largely depend on the quality of surface treatment.
Kazem Reza Kashyzadeh +2 more
doaj +1 more source