Elastic–Plastic Modeling and Experimental Characterization of Granular Jamming Actuators
Advanced Engineering Materials, EarlyView.Granular jamming enables rapid switching between soft and rigid mechanical states. Here, a reduced‐order elastic‐perfectly‐plastic beam framework captures pressure‐dependent loading, unloading, residual deformation, and hysteresis in jammed beams, while matching three‐point bending experiments across materials and geometries. The framework links design
Saheli Patel +2 more
wiley +1 more source
Influence of the Number of Inserts Used for Face Milling on Cutting Forces and Surface Roughness. [PDF]
Materials (Basel)Horava C, Reznicek M, Ovsik M.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.A high interstital austenitic steel is additively manufactured and postdensified by HIP to eliminate gas porosity. Thereby, the loss of N and Mn in Ar HIP atmosphere is investigated. Further, HIP using N2 atmosphere is investigated which led to excessive nitride formation.
F. Großwendt +4 more
wiley +1 more source
The Influence of the Machining Parameters of AW-7020 Aluminum Alloy Shafts on the Surface Roughness, Cutting Forces, and Acoustic Emission Signal. [PDF]
Materials (Basel)Dudzik K, Labuda W.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.PUF/ENB microcapsules were synthesized based on a sequential factorial design and incorporated into an epoxy matrix. Their anticorrosive action, associated with the self‐healing mechanism, demonstrated that the addition of microcapsules to the coating improved anticorrosive performance compared to pure epoxy coatings, particularly when the encapsulate ...
Vandicleya Alves Moreira +6 more
wiley +1 more source
Optimizing Cutting Parameters for Enhanced Control of Temperature, Cutting Forces, and Energy Consumption in Dry Turning of Ti6Al4V Alloy. [PDF]
Materials (Basel)Herrera Fernández M +3 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Additive manufacturing introduces pronounced microstructural and crystallographic anisotropy in Ni‐based superalloys, resulting in orientation‐dependent creep deformation and damage. This review identifies the key microstructural origins of creep anisotropy, examines their influence on dominant deformation mechanisms, and highlights processing ...
Chandan Kumar +3 more
wiley +1 more source
Experimental Analysis of Effect of Machined Material on Cutting Forces during Drilling. [PDF]
Materials (Basel)Sklenička J +5 more
europepmc +1 more source
Impact of Hydrogen Incorporation on Electronic and Magnetic Structure of X2CrNi18‐9 Stainless Steel
Advanced Engineering Materials, EarlyView.Hydrogen uptake in austenitic stainless steel alters both its electronic and magnetic structure. Seebeck measurements reveal hydrogen‐induced shifts in the electronic density of states, while neutron scattering uncovers nanoscale inhomogeneities that grow upon hydrogen incorporation, with the most pronounced effect observed in the PBF as‐built state ...
Torben Tappe +9 more
wiley +1 more source
Analysis of Cutting Forces and Geometric Surface Structures in the Milling of NiTi Alloy. [PDF]
Materials (Basel)Kowalczyk M.
europepmc +1 more source