Results 11 to 20 of about 391,162 (302)
Записки Горного института, 2021 An increase of components production for the equipment intended for oil and gas production is a key factor for analyzing existing technological processes and searching for new technological solutions to improve the efficiency of the production process ...
Irina N. Khrustaleva +3 more
doaj +1 more source
Analysis of correlations between the fractal dimension and parameters of milled surface roughness
Технічна інженерія, 2023 The functional properties of products depend on a number of factors, with one of the main factors being the texture of their surfaces. This explains the considerable attention paid to the determination and formation of such parameters of the machined ...
N.O. , O.I. , A.M., L.Ye. , O.L.
doaj +1 more source
The process of metal and alloy micro-milling: an analytical review
Технічна інженерія, 2023 The demand for miniature, high-precision products is growing rapidly in many industries, which is driving the need for efficient manufacturing technologies. Micromilling is the most universal process for micromachining of metals and alloys.
O.O. , N.O.
doaj +1 more source
Омский научный вестник, 2023 The article discusses the content of the methodology for assessing the technological state of the machine tool system based on the method of planning experiments for cutting pre-designed and manufactured for special precision characteristics of ...
L. R. Safarova +2 more
doaj +1 more source
Influence of cutting parameters and plasma cutting mode on cutting quality and process noise [PDF]
Manufacturing Technology, 2020 Plasma cutting is an ever-evolving method of industrial cutting of materials. Like all modern methods, it must meet the requirements for the quality of the cut, but also the hygiene and safety regulations set by European legislation. New ways are being sought to reduce process noise while improving the quality of the cutting surface.
Marie Kolarikova +5 more
openaire +1 more source
A new mechanism for saturating unstable r-modes in neutron stars [PDF]
, 2013 We consider a new mechanism for damping the oscillations of a mature neutron star. The new dissipation channel arises if superfluid vortices are forced to cut through superconducting fluxtubes.
Andersson, Nils +2 more
core +3 more sources
Study of the effect of cutting modes on output parameters under high-speed steel turn-milling
Advanced Engineering Research, 2022 Introduction. The article elucidates increasing the efficiency of turn-milling of powdered metal high-speed steel products. Turn-milling can be used as an alternative to the traditional turning method. The article describes advantages of the turn-milling
D. A. Matlygin +3 more
doaj +1 more source
Experimental study of the effect of rock blasting with various cutting forms for tunnel excavation using physical model tests [PDF]
Archives of Civil Engineering, 2021 Cutting blasting has been widely used for tunnel excavation. The cutting forms significantly influence the blasting effect. This research focuses on the study of the relationship between cutting forms and blasting effects.
Huaming An, Yushan Song, Deqiang Yang
doaj +1 more source
Experimental study of coated carbide tools behaviour: application for Ti-5-5-5-3 turning [PDF]
, 2011 The goal of this paper is to study the relation between the input data (conditions and geometry of cut) and answers (wear of tool, forces and cutting temperatures) when machining the Ti-5-5-5-3 alloy treated. This study has shown that the cutting process
Baili, Maher +3 more
core +4 more sources
Technoeconomic and thermodynamic aspects of the edge cutting machining optimization
Advanced Engineering Research, 2016 The investigation objective is to develop a calculation method of selecting the optimum cutting speed corresponding to the minimum tool-wear rate. The analysis of the known optimization criteria such as tribological, thermal, energy and thermodynamic ...
Anatoliy A. Ryzhkin +3 more
doaj +1 more source