Laser cutting tobacco slice experiment: Effects of cutting power and cutting speed
Open Physics, 2022 Due to their low melting point, low strength, uneven thickness, and sugar and moisture content, tobacco slices are very sensitive to the requirements of cutting parameters.
Li Pengfei +9 more
doaj +2 more sources
Influence of wood properties and technological parameters of processing on cutting power in milling of thermally modified beechwood [PDF]
Glasnik Šumarskog Fakulteta: Univerzitet u Beogradu, 2011 The paper presents results of influence of thermal modification on cutting power required for milling wood processing. The experiment was conducted for the different treatment temperatures (170°C, 190°C and 210°C) and different technological ...
Mandić Marija +3 more
doaj +1 more source
Experimental Study on the Oxidation and Diffusion Behavior of Inconel 625 and Tool Materials
Crystals, 2018 Oxidation and diffusion simulation experiments were conducted to choose the most suitable material for cutting the Inconel 625 superalloy. Three tool materials, WC/Co, coated carbide, and ceramic were used as tool materials in the oxidation simulation ...
Erliang Liu +5 more
doaj +1 more source
Investigating the CO2 laser cutting parameters of MDF wood composite material [PDF]
, 2011 Laser cutting of medium density fibreboard (MDF) is a complicated process and the selection of the process parameters combinations is essential to get the highest quality of the cut section.
A.G. Olabi +18 more
core +1 more source
BioResources, 2023 The aim of the conducted experiments was to determine the effect of selected machining parameters on power consumption and surface quality obtained during the milling of beech wood using a computerized numerical control woodworking machine.
Magdalena Piernik +2 more
doaj +2 more sources
Applied Sciences, 2022 With nuclear power plants worldwide approaching their design lifespans, plans for decommissioning nuclear power plants are increasing, and interest in decommissioning technology is growing.
Kwan Kim +5 more
doaj +1 more source
Effect of process parameters and optimization of CO2 laser cutting of ultra high performance polyethylene [PDF]
, 2010 The aim of this work is to relate the cutting edge quality parameters (responses) namely: upper kerf, lower kerf, ratio of the upper kerf to lower kerf and cut edge roughness to the process parameters considered in this research and to find out the ...
A.G. Olabi +13 more
core +1 more source
A comparative study of using spindle motor power and eddy current for the detection of tool conditions in milling processes [PDF]
, 2015 This paper investigates the use of the power of the driving motor of a CNC spindle in comparison to two perpendicular eddy current sensors for the detection of tool wear in milling processes. Monitoring the power through the current profile is a low cost
Abbass, JK, Al-Habaibeh, A
core +1 more source
Electroplastic cutting influence on power consumption during drilling process [PDF]
, 2016 The aim of this study is to report the use of non-conventional material removal process technique. It was found that electropulses (EPs) assisted drilling process improves the material machinability based on the eletroplastic influence.
González Rojas, Hernan Alberto +3 more
core +2 more sources
Research of cutting power with cutting chipboards with different properties by circular saw [PDF]
Tehnika, 2015 In this paper elaborates the process of measuring cutting power which occurred during cutting six types of particle board. Chipboards with different physical and mechanical properties were cut in order to find some correlation with the cutting power ie ...
Stanojević Damjan M., Danon Gradimir J.
doaj +1 more source